Ebc Repair In Sydney?

[Super Drager]

Hey guys was just wondering if there is anyone in sydney who can repair electronic boost controllers. Bought a profec B spec2 a few months ago and since installing it along with a new MAC valve and valve unit harness i cannot get the car above wastegate pressure. No matter what changes are made, it reads 0.48BAR and can creep up to 0.52BAR on a cold night. Solenoid clicks when 12V is applied too so its as if the unit itself is not signalling the solenoid to do anything. I've been told its a common problem on these EBC's.

Edited November 21, 2014 by Super Drager

[GTSBoy]

Open the unit and look for burnt resistors, burnt tracks, popped, domed or leaking electro caps, scorched transistors, etc. Any and all of these would most likely be on the circuitry associated with the solenoid output, which you should be able to trace back from the loom plug that goes to the solenoid. If you see anything, get someone who is handy with electronics to replace them.

[Ben C34]

I would use a bike pump to apply pressure to the ebc signal hose, which should in turn make the solenoid do its thing, and check the wiring thoroughly.