-
Posts
339 -
Joined
-
Last visited
-
Feedback
100%
Contact Methods
-
Website URL
http://
Profile Information
-
Gender
Male
-
Location
Canberra
Profile Fields
-
Car(s)
Skyline R33
5hiv's Achievements
-
nsw/act FERREA 1 mm valve set for RB25 neo
5hiv replied to 5hiv's topic in For Sale (Private Car Parts and Accessories)
$1000 Need it gone soon as I want to finish my fuel system. -
nsw/act JE Forged RB30ET piston
5hiv replied to 5hiv's topic in For Sale (Private Car Parts and Accessories)
Sold please delete Thanks -
5hiv started following FERREA 1 mm valve set for RB25 neo
-
JE Forged RB30ET piston JE forged RB30 turbo pistion. Its brand new just been fitted to the engine. I got sent the wrong piston for my build as i needed a non turbo one and after installing it we found out that it is not the right piston that i needed and not the right CR ratio for my setup. Its 87mm Part number : 253900SRP Rings are all setup and ready Can find more info about the piston on the link below, just look up part number (253900SRP) http://precisionintl.com/CategorySearch.aspx?Cat=1&Brand=SRP&Make=28 $850
-
Hey man massage Taarks. I got a raditor support for my R33 from them brand new for $285 posted to my door. but that was only the top part. They are very helpful Email address is [email protected]
-
Wheel Sizes & Offsets For Skylines
5hiv replied to Sydneykid's topic in Suspension, braking and tyres
I have decided that i will be going with the 18x9+30 for the front and 18x10+30 might need to go a smaller tyre -
Wheel Sizes & Offsets For Skylines
5hiv replied to Sydneykid's topic in Suspension, braking and tyres
Hi guys im looking at getting a new set of wheels for my R33 GTST, thinking of getting a 18x8+30 on the front and on the rear 18x10+30 Just want to know if i get 18x9+30 or +15 will it fit without any problem on the front with 235 or 245s Rear will be guard rolled and a little pumped to fit the 18x10+30 or should i get a +15 and lowered with 285s Also if any one has a similar set up on their R33 GTST please post a pic so i can have a look Right now i have 18x8.5+38 front and 18x9.5+38 rear with 235f and 265r with no guard work -
Bump This will bolt onto a Rb25 stock manifold with a spacer and longer studs, new oil water lines and a 5 bolt dump pipe
-
Admin please delete this one as i dont know how it got posted 2 times Thanks
-
GT3082r with T3 5 bolt garrett .63 rear housing and Kinugawa Adjustable Wastegate Actuator Came of a R33 gtst which was a low mount setup $1200
-
GT3082r with T3 5 bolt garrett .63 rear housing and Kinugawa Adjustable Wastegate Actuator Came of a R33 gtst which was a low mount setup $1200
-
I think i have a spare injector wiring loom Will check and get back to you
-
The Rb30 engine i have came out of a R31