NeilC

Hi all. Chasing a pair of front shocks for an R34 25GT sedan. Dont want coilovers etc just a set of standard front shocks in good condition. PM via the forum or text to 0434485474. Am located in Gippsland but can travel to pick up.

Interested in a sedan? Or have your heart set on a coupe. Send me a pm if interested.

Try this it worked for me. If four door lower and then raise rear windows holding the switch on for a couple of seconds after window shuts. Repeat on passenger front window and then on drivers window. If two door coupe just passengers then drivers.

Part number is valid. I googled it before posting although would guess its been superseded a few times. Have blown them out with the compressor and then washed them in warm water and detergent. Have come up ok so will reuse when they dry.

Pulled the pollen filters out of my R34 today. Totally filthy and yuk. Have put system back together without them atm. Anyone know if they are available in Aus? Part Number is 27274 5L500. Is is ok to run without it?My Prado didnt have one fitted either and apparently most Aus spec vehicles around 2000 to 2005 werent fitted with them.

Thanks Brennan. I suspected as much as this only started when the weather warmed up but I didnt tie the two together at the time. Oh well another expense to add to the list.

This misfire started about a week ago. Prevalent at low revs between idle and about two grand. My first thought was plugs so I changed them out for a new set. Car is R34 N/a by the way. After putting everything back together the car ran like a clock. Whilst I had it apart I physically checked the coil packs which look brand new btw. They are green coloured and as far as I am concerned not the original ones. Am concerned because they are only held in by one bolt the second hole on the pack does not line up with the other bolt hole. Is this normal? Also the laminated steel coil the bolt goes through is loose in the coil body as well. Today coming back from Melbourne in the heat it has started to miss again the same as before so am thinking coil pack/s. Am sure genuine packs have a nissan logo and part number on them. The packs for my CA18DE Exa do. Any ideas or thoughts as this just adds weight to my suspicions about things that were changed at compliance. (Headlights changed for a crappy faded set of halogens, child safety anchors not fitted properly and some other little odds and sods) All I will say about the mob that brought this car in to the country and complianced it in March last year is I dont like munching on curry if you get my drift. Oh not to mention the crap tyres they put on it as well. I dont even know if the standard wheels on it now were on it when it landed. Anyway rant over. Advise please.

Thanks fellas. Will check the clutch freeplay as well but it seems to be fine. Pretty sure its the wrong oil. Smells the same as the 80m90 shit you put in the old ford and holden gearboxes and diffs. Stupid flaming Indians.

Car: 2000 R34 25GT N/A Trans: 5 speed manual Problem: Extremely hard to get into gear when cold and very notchy till she is fully warmed up. Car was brought into Aus in March 2013 and complianced and registered in May 2013. Presumed mileage on the paperwork I have was 70,331km. I am second owner in Aus. According to the paperwork I have all fluids were changed. I have checked the level in the gearbox and it it fine. However the oil put in smells like normal 80w 90 MINERAL oil which I know is not correct. I want to change oil but my question is what if any damage may have been done to the gearbox since I have had the car. Problem as I said is only when cold and motor running. Clutch feels good and seems to be releasing properly. Any thoughts appreciated.

Spotted yesterday nice black R34 sedan turning to go into mid valley shops at Morwell. If you are on here I was in the other R34 coming out.

Need the central locking actuator for a R34 4 door sedan front passenger door. 2000 model series II. Actuator is black in colour not white. I believe white is series I and has different plug. Will take complete door lock assembly if I have to.

Thanks all. We ended up not going that way. Sourced an engine out of a wrecked R33 in Sydney. car now back on the road. :-)

A lady friend of mine has an R33 sedan and has blown the engine. She has been offered a complete de Neo out of a wrecked R34. Did a bit of a search but didnt get a definative answer. A couple of questions: 1. Will it fit up to her auto box. 2. Can it be made to run on the R33 ecu etc. or will it need the neo ecu and a rewire. 3. Any other mods needed. Sensible answers please fellas I just need to know what would have to be done if its possible. Engine is in really good nick I am told and she can get it for very low dollars.

@ Ravi those are the standard version of the platinum and iridium plugs. They would be fine except that they dont last as long. Main reason for using the others I reckon is because its such a bitch to change the plugs on a neo engine. Magna V6 engines have platinum plugs on the rear bank for the same reason . You have to dismantle half the engine just to change them.

Hmmm looking through what you have replaced leans me towards fuel being the problem and not overfuelling but rather the opposite. Have you had the fuel pressure itself checked? How much mileage on the car? I would have your fuel pump checked if I were you. Also your O2 sender. Is it using more fuel than before? Also what fuel are you running?