Jump to content

Soulessdeath

Members
  • Content Count

    3
  • Joined

  • Last visited

  • Feedback

    0%

Community Reputation

0 Neutral

About Soulessdeath

  • Rank
    Rank: RB20E

Previous Fields

  • Car(s)
    R32 GTS-T Nissan Skyline
  • Real Name
    Raimon

Recent Profile Visitors

402 profile views
  1. Building rb30det So i am going to start building a RB30DET to go into my r32 gts-t and i am after opinions on the parts i am looking at using so far. Rb30de block - already has turbo provisions rb26dett head JE forged pistons 0.5mm ovbersized Spool rods 272 degree 10.1 Reimax race camshafts with supporting head mods Proflow intake plenum 6 boost exhaust manifold Borg warner s300sx-e 69mm 1200cc deatschwerks injectors. 3 x top speed 345LPH fuel pumps Yaris coil pack conversion 1.2mm oil restrictor ACL race bearings rb26 head studs will be using a rb26dett gearbox converted to rwd running factory steel rb26 adjustable cam gears Looking for recommendations on ECU Tailshaft drive shafts head gasket
  2. As the title suggests i am looking for a either stock or aftermarket exhaust camshaft for a r32 rb20det engine, needs to have the locator pin intact in the end of camshaft for alignment to the CAS, I am located up in Darwin Northern Territory so will need someone willing to post, Of course i will cover postage costs. Otherwise if needed i will buy a set of 262degree 9.5mm lift camshafts if someone is selling a set cheap.
  3. So i am new here, I joined to try and get some better information on what i should be looking at to get more out of my rb20det, I have read a lot of the build posts, But would like some advice on camshafts, Turbo and injectors. The current setup i have is as follows Rb20det Forged bottom end From what i can remember CP pistons, Eagle rods ARP head studs Turbo is a Garrett GT25 ball bearing Currently on 13psi Split fire coilpacks FMIC 2.5 inch piping Full 3 inch exhaust system - Stock manifold Stock ECU Stock 270cc injectors Automatic Transmission- Not going manual ​Has greddy cam gears but the threads are stripped out. I am looking at 260deg 8.8mm camshafts and a set of tomei adjustable cam gears 720cc Injectors Nistune ECU What would others recommend to get a bit more out of the engine and will the camshafts i have picked suit properly. There are not many engine builders up here in the NT so am looking to forums for suggestions. I will not WILL NOT swap to a different engine. Also does anyone know of a ECU that will support Automatic transmission?
×
×
  • Create New...