CaSkidda

Perfect! Found the issue between headlight switch and indicator stalk. Dont know exactly where the break is but just cut and rejoin with new wire between the 2. Thanks alot for the manual, makes it alot easier to know for sure what should be going where.

Thanks Joshua. Greatly appreciated. Will have a hunt through this, hopefully the gtr and gts light wiring is similar enough

Is there really no wiring diagrams available for r32 headlights?

Hi. This is the plug into the rotary switch? If so, yes I have checked it. Also confirmed inputs and outputs back probing this plug. Thanks

Gidday Im having a nightmare of a time with my r32 headlights. I bought the car as a half finished project(original ca18, manual. Now rb20det, full 5 stud subframe setup) All lights work, except headlight low and high. High will work via the flash switch. I have researched and found common faults with the headlight rotary switch. I have stripped the switch, cleaned up all contacts, and confirm power in, and then switched power out of this switch. My problem now is between the switch and the lights I am losing that feed. I have searched alot for a wiring diagram to try and trace the wiring without having to remove the dash but cannot find one at all! I had contemplated running new low beam wires from switch to lights, but then I will still have high beam issues. Any help on this would be greatly appreciated. Cheers

Yeah so I bought this off a mate, he purchased the 5stud as a complete assembly. the way it had drive is just due to the cv nut being tightened, clamping the cv to the hub. I may just pop the CV off, but Im hoping someone will know if the other CVs, inner spline could and diameter is the same so I can virtually just swap them over.

Hi guys. I have recently purchased an R32 that was factory manual ca18. Its been converted to rb20det, and 5 stud conversion. I believe the 5 stud is from a GTS-4. My issue is as I was backing it into the garage, I lost drive. upon looking into it I found the axle/CV was spinning inside the hub. I stipped the hub off and found the cv has 29 splines and the hub is 32. Im unsure what the best option here is, whether I can get 32 spline cvs and fit them to my axles? whether I can get other axles that will suit or whether I need different hubs? the current axles are 5x1 which from what I have read are the stronger of the 2? Any help would be greatly appreciated. Thanks