Jump to content
SAU Community

jimmytim

Members
  • Posts

    175
  • Joined

  • Last visited

  • Feedback

    0%

Everything posted by jimmytim

  1. Got mine replaced at a local workshop for $138 included lab. It's the exide battery though, but including lab, will do. If you're interested let me know and I'll pm the address.
  2. Items for sale: R33 S2 AFM - $100 Pink sticker Stock R33 S2 Coil Pack of 6 - $120 mint condition 1x Stock R33 rim in good condition - $30 pickup only Blatz USB cousult cable - $50 Pickup welcome at doncaster east. postage at buyer expense, registered post only.
  3. Okay.... Bring a piece of wire or paper clip and a torch with you. http://pinoutsguide.com/CarElectronics/nis...ag_pinout.shtml While the car is off, jump pin 4 and pin 8 on the consult port (under the interior fuse box), turn ignition to on (do not start engine) The abs light should start flashing with error codes. ABS CODES Code No. Malfunctioning Part Reference Page 12 Self-diagnosis could not detect any malfunctions. 45 Actuator front left outlet solenoid valve 46 Actuator front left inlet solenoid valve 41 Actuator front right outlet solenoid valve 42 Actuator front right inlet solenoid valve 51 Actuator rear right outlet solenoid valve 52 Actuator rear right inlet solenoid valve 55 Actuator rear left outlet solenoid valve 56 Actuator rear left inlet solenoid valve 25 *1 Front left sensor (open-circuit) 26 *1 Front left sensor (short-circuit) 21 *1 Front right sensor (open-circuit) 22 *1 Front right sensor (short-circuit) 31 *1 Rear right sensor (open-circuit) 32 *1 Rear right sensor (short-circuit) 35 *1 Rear left sensor (open-circuit) 36 *1 Rear left sensor (short-circuit) 18 *1 Sensor rotor 61 *3 Actuator motor or motor relay 63 Solenoid valve relay 57 *2 Power supply (Low voltage) 71 Control unit Now write down the codes with a pen, then clear the fault codes Disconnect the check terminal from ground (ABS warning lamp will stay lit). Within 12.5 seconds, ground the check terminal three times. Each terminal ground must last more than 1 second. The ABS warning lamp goes out after the erase operation has been completed. Turn ignition to off, remove the wire/paper clip, then start the car & go for a drive. If abs lights up again, do the same to check the code.
  4. From experience there is no one place that does it all, you just have to call around. Have a look here: http://www.skylinesaustralia.com/forums/Lo...ops-t13305.html give those workshops a call and see what their advise is. You may need to find a sparky or air con specialist near you. BTW, don't bother calling Nissan, they won't touch your car.
  5. Cool, thanks! I'll give them a visit
  6. Hello all, sorry to raise an oldish thread. Is Traction Tyres this place? http://www.tractiontyres.com.au/ Thanks!
  7. I bought some from Repco last year, the round ones that is. I think they come in a pack of two.
  8. You may wish to follow the following: (ignore point 1 & 5) Follow the red arrow
  9. Had this problem once when I got a complete flat battery. Just connect to the ecu via consult port and reset it.
  10. Hi all! Really quick question. A 96 R33 GTS-T AT series 2...which one is the "Throttle Position Sensor Connector"? The grey one or the brown one? Thanks heaps!
  11. Great, only if I remember (or someone reminds me...I sure will forget)
  12. Why don't they just put a camera (and night vision) in front of every truck...or even front parking sensor...those ones that beeps extremely loud inside
  13. I've tried V-Power Racing last year sometime... You start the car in the morning...the idle just drop to around 500rpm as in wants to die, then it rev's itself... Use 98ron again, starts normal everytime. Didn't notice any difference at all.
  14. jimmytim

    Purchase Car

    Shane let me played with...five cars before I decide on which one to get
  15. I'd love to get a copy (provided we're not breaking any laws) BTW, all you need is DVD shrink (this rips it to the hdd and region free the disc)
  16. Yeah, it is the D1 can.... I've checked the can, it is dry as... There really isn't any point in running it
  17. Well, to rule the steering lock out, just try it (turn the wheel about 45 degrees to the right without the key in the ignition, it should click and lock the wheel)
  18. ICIC.... Would be good if they have a quick release with air bag though (I don't know if there is any)
  19. Has it got anything to do with the airbag or steering lock?
×
×
  • Create New...