Search the Community

Hi guys, as title states, I'm in the market for a 3 inch (MUST BE 3 INCH) catback to suit a R32. Want something that's in decent condition, no rust/holes/dents etc. Preferably something in NSW but if from other states, I don't mind paying postage, as long as it's good Please PM me if you have anything, thanks! Josh.

After a couple of things for my r34 25gt coupe (non-turbo) 1. Catback exhaust 2. GTR Z-tune front bar that fits a gt Looks like this

Please delete, tidy up and combine into one post

Hi guys I need to borrow, rent or buy a stock R33 catback to pass EPA. I don't think I'm gonna pass with my current 3" catback. Can anyone help me out? Thanks!

So, I purchased a project R33 S1 Skyline, unfortunately it came with a RB20e... (would engine swap but I’m on my P’s ) I’ve been hunting for ages trying to find an exhaust but I have had no luck.. Does anyone know if I could bolt up a rb25de (aftermarket) catback to my rb20e and all fit up? Any help is greatly appreciated!

Hi guys, Has anyone replaced their exhaust middle muffler with a resonator? If you did, what happened to the noise levels? I've got an R34 GTT sedan with an R33 HKS Super Drager (the one with the massive rear muffler) modified to suit, but the middle muffler is sitting really low and regularly scraping. I'd like to replace it with a resonator (to run under the transmission tunnel) but I like the relative quietness of the exhaust system as it is, so I don't really want to make it louder... Also, what catalyser would you recommend to flow 300rwkw? Needs to bolt on to 3" flanges. I'm thinking a 200cpi metal cat of some kind. I've got an X-Force ceramic high flow currently but it's suspected of restricting flow. Thanks!

Exhaust help Hey everyone so I own a 1994 r33 gts skyline as a daily and when I got it, it came with a 4" Just jap cat back system, I've recently found out that I have a leak in my exhaust but it's coming from behind the cat, and I'm stuck in debating wether or not to replace the problem with extractors, but some people have told me I'll only be getting restriction due to my cat and have told me to get a hi flow cat, Would anyone on here be able to tell me where I could get a 4" cat for my exhaust and extractors and what brand extractors I should get? I've been looking at just jap ones I'm located in Wollongong NSW but have no problem traveling to the city

R32 Nissan Skyline GTR: Exhaust Sounds of Blitz NÜR-Spec Catback - Free Rev & Acceleration Apologies for my terrible on-camera performance, we sort of rushed through this to get it made, ha ha. Anyways, I made a quick video on the exhaust sounds of a Blitz Nur-Spec catback on a mostly stock R32 GTR. Enjoy, lol.

HKS Silent Hi Power Catback for 32 GTR Hi all, I'm considering replacing my catback exhaust on my 32 gtr. Hearing a bit about the hks silent hi power exhaust, anyone have any details on this catback i.e. any restrictions, noise at idle and high rpm (given I'm running 19psi). Don't want anything too loud and needs to meet noise restrictions at wakefield park. Also if anyone has one for sale in the sydney area what price are you chasing?

Hey guys, have a few different exhausts from Ceffy's and Laurels Twin Muffler/Tip 3" Stainless Steel Cat-back Exhaust w/ Silencers - $450 --------------------------------- Single Muffler Stainless Steel Cat-back Exhaust - $300 --------------------------------- 3" Stainless Steel Cat-back Straight Through Exhaust (rough condition - $150 All Located near Mitcham in SA, can send anywhere.

Front/Dump Pipe/Exhaust Help Hi guys. I want to upgrade my stock dump/front pipes and cat on my R34 GTT. I don't wanna go overboard. It's just a daily driven car. Right now I have a SR JASMA cat back exhaust. I think it's 3", but I am going to replace it with a Blitz Nur Spec cat back later on. Firstly, I would like to replace the front/dump pipe. I saw this on just jap: http://justjap.com/jjr-stainless-3-bellmouth-front-dump-pipe-nissan-skyline-er34.html JJR Stainless 3" Bellmouth front/dump pipe And this cat: http://justjap.com/x-force-3-stainless-high-flow-cat-nissan-type-3.html X-Force 3" Stainless High Flow Cat Question 1: Would these two pieces bolt up together? i.e would the flanges mate up perfectly? Or would I have to modify them? Question 2: When you put the pieces together, do you have to use some special silicon between the gaskets? or do you just use the gaskets they provide? Question 3: Is it very important that you need a tune after the installation, or can i just adjust my boost controller down a notch and all is well? Question 4: Would it be a good idea to wrap the front/dump pipe in Titanium wrap or waste of $$ and time? Question 5: What is the cell rating on that x-force 3' cat and is it a good buy for a daily driver expecting a little more power gain (with supporting mods in future ofcourse)? R34 GTT Coupe Manual RB25Det, stock turbo, FMIC, stock ecu, boost controller,

Hey guys selling RB25 R33/34 na exhaust headers with catback exhaust No holes or leaks anywhere 2.5" pipes with highflow cat exhaust was put on by Pipewerx in Brisbane pick up in rockhampton or surrounding areas (will deliver if close enough) or can ship at buyers expense looking for around $300 ono or swaps for any parts of interest (check other topics) contact either through here or on 0458585306

All items located 2210, Sydney. Will post at buyers expense Send me a pm for more info R34 Dump pipes Stainless steel ​Good condition Better flow than 32 & 33 items Bigger outlets than 32 & 33 items (60mm) $250 ono Kakimoto Racing R Catback R32 GTR Full 80mm exhaust Stainless Over $1000 shipped new - http://www.nengun.com/kakimoto-racing/kakimoto-r Nice sound Good condition $400 ono Impul Front pipes 70-80mm Discontinued part, pretty rare Great condition, awesome looking part comes with 3 gaskets Suits R32, R33, R34 GTR $200 ono Custom 2.75 - 3.5 inch Front pipe Stainless 3.5 inch outlet tapers to 80mm at the flange would be easy to cut and weld bigger flange suits R32, R33, R34 GTR $200 ono

Hi guys, I had a mate build me a cat-back exhaust for my 32,its 3.5 inch diameter stainless steel system. It has an x force muffler and resonator. It's been driven twice since it was fitted, and I've decided to go in a different direction. I'm looking for 800ono, I'm located near hornsby in Sydney

Trust Titanium Cat Back Exhaust R32 GT-R Selling a Trust Titanium cat back exhaust to suit an R32 GT-R (maybe GTS-t?) Light weight and high quality exhaust, in excellent used condition, no dents, obvious scratches, etc. Does have a few water marks so could do with a polish of some sort. See attached photos. Appears to be 3" (76.5mm) internal diameter, 115mm tip, comes with original documents & Jasma certificate. Located in Brisbane, looking for $1400 ONO, can ship at buyers cost.

Suuuuuuuuuuuutututuututuuuuuuuuuuuuu dose is life. Harro betches, Up for sale is my old 3" cat back exhaust which has been on my car for a while. It has gone through a few changes over my ownership. Started off stock with the stupid taper in the resonator...so I chopped it off and replaced it with a 3" straight through resonator. 3x weeks later, I wanted it even more quiet so I proceeded with adding a 3" mid muffler. It really shut things up. I can now have long d&ms in the car with the missus whilst listening to smooth FM without any hint of drone or bullshit......... until I crack the gate. So what are you getting? R33 GTS(-t) 3" Fujitsubo Cat Back Exhaust with: 3" X-Force Straight through Resonator 3" X-Force Straight through Mid Muffler Bolts/nuts for the rear section A part of the shit box's legacy of choppage If that excites you enough, and you want a car that is actually quiet, fun to drive and not a total cop magnet.. then this is the exhaust for you. Condition: Decent, a few grazes but no dents on mufflers or resonator, however a slight decent on the rear piping. Also 1x pin hole on the last bend as per the photo. Location: Canley Vale, NSW Price: $239.95 (that means $200 firm)

Hey guys, Up for sale is my 2.5" custom catback exhaust coming off my 2door n/a r34. Has a resonator midway and a HKS canon muffler with a nice deep tone to it. Was put together by Blitz Exhausts in Hoppers Crossing. No leaks, have owned it for about 5 months. Selling due to returning my car back to stock standard. Asking price is about $250. Shoot me offers! Photos will be posted tomorrow Thanks Located in Western Suburbs of Melbourne. Pick up only.

Have for sale a factory complete exhaust system that came off an Nissan 200sx s14 series 1. Includes dump pipe, what looks to be a high flow cat (unconfirmed), and cat-back with the original twin tip muffler. Has been in storage for a while, but is in good condition, hangers are all intact and still has the original heat shielding. Selling as a whole, make an offer, need it gone... $250 Pickup from Lidcombe, NSW. Contact on zero four one five 549514

Pickup only at this stage from Mount Gravatt Brisbane.I can drop it off locally. From a r33 gtst coupe but should also fit r33 four door's. In very good condtion,Has some light scratches on the bottom. Asking $250

Hey guys, have a few different exhausts from Ceffy's and Laurels Twin Muffler/Tip 3" Stainless Steel Cat-back Exhaust w/ Silencers - $450 --------------------------------- Single Muffler Stainless Steel Cat-back Exhaust - $300 --------------------------------- 3" Stainless Steel Cat-back Straight Through Exhaust (rough condition - $150 All Located near Mitcham in SA, can send anywhere.

HKS hi power silent catback exhaust, 80mm, ran over 340RWKW. Used, less than 2 years old Suit 34GTR, fit perfect with rear diffuser, no droning and a nice note. Replaced it because I went custom setup. Will need 2 gaskets and hardware. Price: $500 SOLD Note pic is of dumps when just coated, they are matt black now after use. R34GTR factory stainless steel dump pipes x2 Used in good nick, off a 99 vspec Flow better than 32-33GTR cast dumps I had them ceramicoated by Craved, includes factory head shields Price: $250 Nismo 555cc injectors Used, had them in my car for less that a year, suit All RB26. pulled them out due to going to 1000cc work fine, should get 350RWKW or so with 98 depending on pump and fuel pressure. Price: $250 SOLD Cam gears, adjustable. Possibly made by racepace, were on car when I bought it. Used, from my 34, these are factory outer gears with an adjustable center. Very durable, cost effective upgrade to suit 32, 33 34 GTR etc. Price: $100 Located in Richmond, western Syd PM if interested. Pick up prefered, I can post smaller items via registered post

as title states 3.5" mild steel catback mid muffler resonator HKS super drager muffler surprisingly quiet. Cat and front pipe are already sold, only shit photo I have. Came off an R33 GTS-T. After $300 picked up. Exhaust is in Wollongong, could be brought to Taren Point for an afternoon meeting. Contact on 0415 954 550.

Selling my Tomei Expreme Ti as im going for a custom made exhaust. Comes with everything as brand new (haven't used consumables like the anti seize thread paste it comes with) In original box. Pretty much brand new and sounded amazing, get yourself a steal. Only had it on the car for a couple days. Was going to get a custom mid section made to slip into this and decided to go full custom instead and sell this (rather than waste half of the exhaust). The thing is so amazingly light I couldn't believe it, the whole system weighs only 7kg, a reduction of over 10kg from stock. pics: Price 1100 neg Can post if needed Vid of how it sounded on the car: http://www.youtube.com/watch?v=mwEQGpIe34M Location: Noble Park VIC Phone: 0425 867 834

Hi guys I have a Blitz exhaust to suit V35 Skyline coupe (should also fit 350Z if you remove about 6inches of pipe length) for sale, located in SA. prefer local buyer but can arrange shipping and negotiate a cost for freight interstate. Item: Blitz Y-pipe-back stainless steel exhaust to suit V35 Skyline coupe Condition: Used. Average wear and tear. slight rattle in mid muffler. No holes or dents. Reason For Sale: i have recently ordered a Powerhouse Amuse R1 Titan exhaust hence i'm selling this one. Description: The exhaust came with the car when i bought it. It looks subtle and sounds nice, just a bit deeper than stock and a nice growl in mid to high rpms. (obviously sound depends a lot on your other mods eg headers, cats/streight pipes, y-pipe, etc). The exhaust is from the Y-pipes back (ie. it does not include the Y-pipe), and will bolt on to your existing Y-pipe. It is a genuine Blitz exhaust, made in Japan, JASMA appoved. Fits nicely in the factory rear bar cutouts. Currently still fitted to my car, will be off in the next couple of weeks. I will update with more photos when it has been removed. Price: $300 or near offer.

Hi guys, Just a couple: 1. Sard/Denso 700cc Top Feed Injectors Comment: They fit a stock GTR rail as pictured, direct drop in. 195500-0830 is the part number. Price: $450 + $15 express post, can come with the rail for $500 posted to your door. 2. R33 GTR/GTST 3.5" HKS Super Drager/Dragger Catback Comment: This came off a R33 GTR, sounds really good. Should fit a GTST I believe from what others have said. The axle back is in super condition, must have been polished at some stage. The cat to axle has scrapes from a speed bump. See the photos below. Price: $400 + postage - Can arrange a courier, shouldn't be relatively cheap. Has a Gutted standard cat at the moment as well, will throw in for $50. OR For Sale: $75 Stock Gutted Cat + postage Located in Brisbane. Photos (If you need anymore, send me a message: 1. Injectors [[ 2. HKS Super Drager