Search the Community

R32 GTR Morimoto Mini D2S 4.0 Retrofit So after numerous ridiculous nights driving without adequate lighting in my R32 Skyline. I decided to do something about it. I reached out to TRS customer support and they began to point me in the right direction. I made a few additional calls to a couple of individuals TRS referred me too as they had completed retrofits on a few R32's as well. After these insightful discussions I boiled it down to going with either the Morimoto Mini H1 7.0 or the Morimoto Mini DS2 4.0. After numerous recommendations I chose the DS2 4.0! I placed my pre-ordered through TRS and waited patiently for these bad boys to come in. As soon as they arrived it was time to get to work. First of all I must say the quality and design of these are incredible, but they weren't going to install themselves. After staring at them for at least 2 hours and surfing numerous forums on previous retrofits it was apparent that I was not getting this done without hacking at my OEM projector. See the DS2 is significantly smaller and shorter than the OEM projector so I would need a bracket to step up to the OEM placement. What better bracket to manipulate than the OEM. I proceeded to cut the OEM housing leaving only the OEM frame. (Never mind the blocks they came later. Forgot to take a pic of the bracket when I first cut it) At this point I lined up the DS2 4.0 and used a punch to mark placement of the screws and created and cardboard template to determine what approach I was going to use to secure. I've seen numerous individuals shave the OEM brackets as thin as possible, trim, drill and separate the new projector to mate in between the fabricated OEM bracket. I chose a different route as I did not want disrupt what I assumed to be a carefully thought out design so I ended up welding blocks (about an 3/4" long and a 1/4"of an inch high) along each corner where I originally marked, then drilled holes, and checked fitment a few times, shaving each block respectively using a small level. Ensuring fitment between bracket and OEM bezel I must say final fitment is incredible! secure and as flush as OEM. Only one issue I caused myself was I forgot to trim the OEM bracket to allow the wiring for the high beam solenoid so I took a Dremel and filed away enough space to allow for the connector to secure into the projector. All in all I'm super stoked and can't wait to install on my vehicle.