Jump to content
SAU Community

Recommended Posts

these seats and rails were originally out of a fresh import gtr32 - the owner was quite big and didn't fit. For my s15 (and all silvias/180s), one mounting point was approx. 3cm too short so that bracket was cut off and a new plate welded on by a professional. To have this fit skylines again all you need to do is drill a hole approx. 3cm in, no welding required.

the seats have no branding - choosen because i didn't want to have a big bride/sparco/recaro logo that say "steal me!"

the harnesses can fit with no modifications; if you want to run with the optional 5th and 6th point (that go around your crotch area) then you will need to find a mounting point below the seat.

:)

Link to comment
https://www.sau.com.au/forums/topic/125583-sold/#findComment-2319745
Share on other sites

Any chance of getting some more photos of the seats (front, side and back) in full detail?

Also, I have a coupe; how is this going to affect people climbing into the back as they're fixed buckets

Link to comment
https://www.sau.com.au/forums/topic/125583-sold/#findComment-2319754
Share on other sites

  • 1 month later...

i will sell the drivers side seperately:

drivers side bucket + rail = $550

1 x 3" harness = $250

together = $750

IIRC the A31 rails are the same as R32/33/34 rails, so if i do remmeber correctly the rails will fit your A31 :(

Edited by _Wing_
Link to comment
https://www.sau.com.au/forums/topic/125583-sold/#findComment-2447004
Share on other sites

  • 2 weeks later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Yes the gear for the R33/34 is different, it is red and has a different number of teeth. My part didn't come with that gear though, so I don't know how many teeth are on the red one. You'd have to reuse the 260RS/R33 gear, as long as it's not destroyed.   Haha, as unfortunate as that might be it was working fine for about the first 1500km I've had the car for now.
    • Update all   thanks to the workshop manual, it lead me back to checking fuses as mentioned central locking and door open lights worked when acc was switched on. diagram attached shows two points of power 1. ACC and 2.  Batt with the later being fused (#28) I did check the fuses using a multimeter but I must have stuffed that up also. Went back and checked the batt fuse in interior fuse box and you wouldn’t believe it… a blown fuse. replaced fuse and everything is now working as it should including the climate control   thank you all with your positive insight and knowledge.    
    • Where is the warning "That this thread is super old"   I just went into a 5 year old thread, went to do a reply, and couldn't see anywhere obvious a warning of it being super old
    • Duncan is correct. Pitwork (and Toyota's own cheap brand "Drive Joy") were primarily created as brands to sell other manufacturers car parts. It would be weird if Nissan sold parts for Toyota vehicles with a Nissan logo on it, so they created Pitwork to sell parts for other brans Toyota, Honda etc. They are not the same as Nissan genuine parts, although they *do* meet Nissan's standards for replacement parts. They aren't supposed to be a substitute for genuine parts, but a cheaper alternative that is better than Ebay fake parts from you-know-where.
    • Thanks GTSBoy, much easier to work with it now it's free!  
×
×
  • Create New...