Jump to content
SAU Community

Back To The Skylines!


Murry33
 Share

Recommended Posts

Hello all, i used to own a r32 GTS a while back with full kit, exhaust, rims etc etc. But i missed the great handling and sporty feeling you get from the skyline, so i went and got a skyline again, only this time found a r33 gtst series 2 :D.

I've been using these forums every now and then, and must say adelaide have some very nice skylines around i've seen!, So yeah just thought i'd introduce now haha! Cheers!!

Murry.

So far it's got : sparco racing wheels, exhaust,tint, full alarm+immob, stereo, fmic.

Pic: murrys33.jpg

:)

Edited by NeesaanGTS
Link to comment
Share on other sites

Nice buddy nice.. welcome back. I know exactly how you feel, i had a 32 gts-t and then left skylines for a while to pursue my love for my nissan exa sportswagon, and now i'm back to skylines again.

Link to comment
Share on other sites

nah didn't adz buy Snake's old one - plus it had different wheels.

Haven't had time to chase up the O2 sensor mate - hope to have time tomorrow. A dude on Ebay has then for $88 delivered, so may go that option yet.

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share



  • Similar Content

  • Latest Posts

    • Y'know what, after reading a topic on a 360kw build using a nistune (who ended up going LINK), im now considering a LINK over a nistune. The engine protection alone would probably be worth it. And id like to learn to tune so would be nice to have that safe guard. Which means i probably wont need a boost controller then, or the R35 MAF.  Becoming a bit of a blog now but oh wells. As mentioned previously, the goal is around 300kw, for a daily driver. Will be looking at fitting a highflow turbo or similar (something that doesnt require downpipes, manifolds etc to be changed out) when the current stock gives out or the money for it is there. 
    • Thanks guys. Are you meant to tighten the converter bolts through the starter motor hole? Think my plate between gearbox and engine is one piece. Im heading up there tomorrow.
    • Picked my tailshaft up yesterday arv!! Test fit it and because they've gone to a ford centre bearing and CV I had to modify the mounting bracket a little bit. 5mm of each side and she went up into position and fits well. It has a 1350 uni and flange on the gearbox end so it should be plenty strong!  Got stuck in this morning and started on the wiring mess. Cut out all the wires not required that go to the body connector and cut the engine harness out. Need to go through and work out which ones I need to keep and rewire into the new ecu. Should save a small amount of weight as well. I'd love to get in and rip the dash and everything out to completely remove wiring but cbf.  Next up was the power harness for alternator, starter etc. It has a few connectors from factory that run out of it. Cut it all apart and removed what was no longer required and put some new corro and taped it all back up and bolted it all back into place.  After that I worked out where I can mount the new flex sensor. Found a couple of factory bolt holes and drilled a new hole on the bracket to suit. Need to go get a few fittings and adapters tomorrow so I can keep going.   
    • Nah, im after the more newer looking, one with the OLED display
    • We revised the neutral wire instructions. The old way was wrong.  R34 gearbox change.pdf
×
×
  • Create New...