Jump to content
SAU Community

Will These Wheels Fit On Autech Stagea


260rsstagea
 Share

Recommended Posts

yes, the rears will stick out 10mm more than the bnr34 wheels though.

just remember you'll want to keep the same rolling diameter front and rear when choosing tyres so need to take into account the stagger of the wheels

Link to comment
Share on other sites

true that, you'll need a high disk front to clear the brembos

and in reference to the above, he's already got r34gtr wheels and these will sit pretty much the same - a little tougher on the rear. just watch the clearance between your rear struts and the wheels (depending on suspension setup) if you go lower without camber correction

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share



  • Similar Content

  • Latest Posts

    • And lower chances of a divorce, hookers & coke much higher chance, a bit lower are strippers & coke.
    • Been slowly chipping away at it when I've got time. Tried to get the box in with the converter but worked out that the flexplate isn't the correct thickness and the converter pulls out off the pump too much (about 8mm). The flexplate for some reason was setup to use the secondary holes on the converter which had a press in nut to bolt to. I worked with Adamat performance the guys who manufacture the kits and they revised the design and made it suit the factory converter holes and milled up a new one for me and is currently on its way over. Can see the differences between the two compared to the orignal design which is in the post above. Once that's here the box can go in for good. I dummy'd it back up to get tailshaft length and is currently with Hardy Spicer to sort that out. Unfortunately won't get it back until late Jan Have been working in the boot lately getting it all a bit nicer and useable. Painted it with sound deadener and cut out a new boot floor from 18mm MDF so I can put a pram or my tool bag in the back. Have marine carpet coming to stick onto that and then also cut a piece to cover the battery. Once ive stuck the carpet in and all cleaned up ill pop the fuel system back in. Need to order 2 new Walbro 525s to replace the 3x 460s. Should be enough fuel for the new setup and run a bit cooler as well having more volume in the surge tank and less heat.  Have also ordered some sound deadener to put under the carpet. That should be here next week and I'll start putting it down on the floor, doors and roof. Hoping all this effort will make it a nice streeter with ability to daily if I want to.
    • It's only money. This arrived for mine yesterday 
    • Unfortunately my car was stolen in the last few weeks while I was away. Car towed from garage in brisbane south. Wasn’t running and unregistered but good condition white 1994 series 1 r33 gts-t. Black 17inch kakimoto rims, fujitsubo ti exhaust, gtr drivers seat, hybrid fmic, standard body with m spec front bar.  reward for information that leads to recovery.    thanks
×
×
  • Create New...