Jump to content
SAU Community

Recommended Posts

Gday all

been driving my missus 1996 RS4 Auto Stagea

and at random times when i'm slowing to a stop the revs die and the car stalls

it's recently been serviced engine is completely stock

but has been filled with just plain unleaded fuel (unsure if that matters)

any insight would be greatly appreciated

thanks

Tyson

Link to comment
https://www.sau.com.au/forums/topic/267155-stagea-stalling/
Share on other sites

when i first got my 33 my boss shouted me fuel but his fuel card only worked at the shitty servo with normal 91 and premium 95 or something, and even on the 95 stuff whenever i came to the traffic lights or a stop sign revs would drop to 100-200 and nearly stall, id hate to think how it would run on 91, this is with the stock ecu too btw. now with any 98RON fuel she runs fine never drops under 5-600 rpm

Link to comment
https://www.sau.com.au/forums/topic/267155-stagea-stalling/#findComment-4557339
Share on other sites

i would head over to the stagea section on here there is a few threads about stageas stalling aswell as all the possiblities it could be. Personally i know a few who are running their stag's on normal fuel and have never had an issue.

Stageas stalling is common to an extent and most seem to be able to fix it rather easily....have you checked the filters and fuel filter.. they maybe blocked or dirty? your afm?

but like i said head the stagea section and you find how people fix them or determined what was going on..

Good luck!

Link to comment
https://www.sau.com.au/forums/topic/267155-stagea-stalling/#findComment-4558093
Share on other sites

Sounds like your AFM

had the same prob with my stagea and R33

change out the AFM and see if that fixes it

you could probebly borrow one, only takes about 5mins, will be able to confirm befor spending money at workshops

Link to comment
https://www.sau.com.au/forums/topic/267155-stagea-stalling/#findComment-4560785
Share on other sites

Usually caused by fault Air Flow Meter or Aftermarket Blow Off Valve.

Both are easy to fix, the AFM is the easiest and cheapest to test, you can borrow somebody elses, will only take 15 minutes, if no difference then it's probably related to the blow off valve. Aftermarket blow off valves that vent to the atmosphere (instead of recirculating) will cause most skylines/stageas to stall.

Also as a quick (temp) fix you can unscrew your AAC valve a little (it's a small screw on the intake plenum) this will raise the idling RPM and should make it a little harder to stall (will probably use a bit more fuel and have a less steady idle though).

Link to comment
https://www.sau.com.au/forums/topic/267155-stagea-stalling/#findComment-4562111
Share on other sites

  • 1 month later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Yes the gear for the R33/34 is different, it is red and has a different number of teeth. My part didn't come with that gear though, so I don't know how many teeth are on the red one. You'd have to reuse the 260RS/R33 gear, as long as it's not destroyed.   Haha, as unfortunate as that might be it was working fine for about the first 1500km I've had the car for now.
    • Update all   thanks to the workshop manual, it lead me back to checking fuses as mentioned central locking and door open lights worked when acc was switched on. diagram attached shows two points of power 1. ACC and 2.  Batt with the later being fused (#28) I did check the fuses using a multimeter but I must have stuffed that up also. Went back and checked the batt fuse in interior fuse box and you wouldn’t believe it… a blown fuse. replaced fuse and everything is now working as it should including the climate control   thank you all with your positive insight and knowledge.    
    • Where is the warning "That this thread is super old"   I just went into a 5 year old thread, went to do a reply, and couldn't see anywhere obvious a warning of it being super old
    • Duncan is correct. Pitwork (and Toyota's own cheap brand "Drive Joy") were primarily created as brands to sell other manufacturers car parts. It would be weird if Nissan sold parts for Toyota vehicles with a Nissan logo on it, so they created Pitwork to sell parts for other brans Toyota, Honda etc. They are not the same as Nissan genuine parts, although they *do* meet Nissan's standards for replacement parts. They aren't supposed to be a substitute for genuine parts, but a cheaper alternative that is better than Ebay fake parts from you-know-where.
    • Thanks GTSBoy, much easier to work with it now it's free!  
×
×
  • Create New...