Jump to content
SAU Community

Victorian Post Your Ride Thread


sami`

Recommended Posts

Not sure, would love some meisters or similar (far too expensive though), bit of dish always cool but been eyeing off some concave..

Something like these I've been looking at.. don't look the best in the pics but on the car look decent I think

http://www.tswalloywheels.com.au/products/mirabeau

c2bd321524596af01d30f6e4b63360c74f021b51

doesnt matter i'm too poor atm anyway lol

That guy lives around here see the car a fair bit looks really good

Link to comment
Share on other sites

That guy lives around here see the car a fair bit looks really good

Good to know, I'd probably go the same silver/chrome as well - would be mint on a black car I reckon.

  • Like 1
Link to comment
Share on other sites

  • 2 weeks later...

cheers guys, yeah too many thrashed out heaps these days, they're getting to cheap. Veilside was super nice (& actually almost identical, mufflers different but all 3" piping the same) but always wanted the abflug quad's plus they're loads rarer.

Good eye too, it's actually next door to the cement works in the bowls carpark, bloody thing looks locked up tight! Don't know if it's possible to get in do you?

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • I disconnected before the fuel pump and restriction still there. Disconnected at turbosmart fpr and also after ethanol sensor and pressure dropped. No kinks in line but I found one spot above diff that I can hear the fuel flowing while running so I'm wondering if there is built up corrosion  from 10 years of sitting.  I had injectors cleaned and tested and one was dead but rest were fine. Was never an issue when I owned the car previously but I'll talk to jez about his thoughts on if they should be changed to newer tech. Thx guys at least I know the setup should work again. Pump is wired directly to relay and not using factory plug any  more 
    • Nice work on the shroud/ducting.  
    • Hi and best of luck with your car. Its a bit hard to tell how low the car is all round from that pic or if its been lowered or not. 90mm is a bit low on the front apron but it depends on the shocks & springs condition & whether or not its been lowered. Going to 19” wheels will give you 15-20mm depending on rubber but you might need new shocks. Mine -2005 are weeping fluid slightly but have lasted 19years!!. So if yours are original they need replacing anyway if they havent been touched before.
    • Hi everyone, Recently got handed down a 2004 Skyline 350GT Coupe. I would like to change the wheels as the previous owner installed some weird ones. The current ones are 215/45ZR18, unsure of the offset, and sit pretty deep in. Would like to increase the ground clearance slightly as well as I need to get it roadworthy standard, currently sitting at 90mm. Was thinking that maybe I could kill 2 birds with 1 stone by getting new wheels.  Pictures of current wheels: https://imgur.com/bg1QMIu Any recommendations for the types of wheels I should be on the lookout for? Like the maximum and minimum offset, sidewall height, width, etc.  Sorry in advance if I'm noob, I do not know much about cars other than how to change the oil, a blown tyre and brakepads....
    • Hey MinKer, Where abouts did you get that table from ? 
×
×
  • Create New...