Jump to content
SAU Community

Avcr Help


lindsey34
 Share

Recommended Posts

Does anyone know of any other way?

I am almost certain that when mine was installed they fed it through the drivers side wheel arch, need to remove the plastic inside and you will see two holes with wiring going from the cabin to the engine bay

Link to comment
Share on other sites

mark sounds like he has the right idea. I personally wouldn't use the wheel arch one if your inner plastic guards go like mine have from running 18's on the onevia. I used a screwdriver to push a hole thru the rubber boot on the passengers side of the car (ecu one). I then fed the wires thru.

Link to comment
Share on other sites

Thanks for your help everyone, I finally managed to feed the wires through by removing the glovebox, this gave me better access to the hole that the loom runs through, I got someone to lever the rubber seal up with a flat screwdriver while I fed the wires through.

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share



×
×
  • Create New...