Jump to content
SAU Community

Keep An Eye Out...


SECURITY
 Share

Recommended Posts

So I'm finally going to part-out my r33 because its not worth the time i need to spend on it to get it to where i want it to be so now I'm looking for a 93/4 R32 GTR. I'm going to be super picky when purchasing my next car because i tend to hang on to my cars for a long time because i fall in love too easily.

What im looking for is something CLEAN. My preference is a 94 R32 GTR but if its a 93 with a built engine and supporting mods I will be more than happy to consider it. I would prefer something thats been set up for track work, it must be registered and NOT stand out like dogs balls.

so what im looking for is:

- CLEAN 93 or 94 - straight body

- registered

- power mods

- good suspension set up

- quiet-ish (not stupidly loud)

- decent amount of km (not over 90,000km unless its got a built motor or compression is above 155psi on each cylinder and leak down is well within spec)

If you hear of something i'd be interested in, please give me a heads up. I feel like its going to be a loooong search so any help will be appreciated.

thanks,

joe

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share



  • Similar Content

  • Latest Posts

    • Got quoted £50 per knuckle to vapor hone them, so bought a sand blasting cabinet and did it myself  Pretty happy with the first attempt  I didn't get a before picture, I was too excited to use my new toy  The knuckle was pretty much black though when I started
    • Sounds like all you want is a button on your CAN dash pad that is for 2-step / anti lag launch.  Hold the button down, rev limit gets set to whatever you want, say 5000 rpm. Then mass timing is pulled and a heap of fuel is dumped in for fun times. Want more bangs and flames, pull more timing or add more fuel or both lol.  Obviously the more you use the fun button, the shorter the life of the entire hot side of your motor. So valves, turbo, cat, any sensors in the exhaust, etc etc. Well, if you are using it for its intended purpose it is very rewarding. If you are at the drags and want to launch on full boost, how else are you going to do that?
    • Engines are expensive. You already mentioned having thermal management issues with your car, anti-lag dramatically raises EGTs and can easily damage a cylinder head. If your goal is actually to improve transient response I recommend VCAM. DBW can also help here. Instead of a simple mapping of accelerator pedal position to throttle opening instead you interpret the accelerator pedal as a certain torque/power request and the throttle will open more or less to achieve that. So if your desired acceleration requires getting 0.5 bar of boost the throttle will silently go wide open to spool the turbos, then as it gets to that target intake manifold pressure it will adjust the throttle back to the steady state target. Another trick you can play is detecting when a shift is happening using a strain gauge and clutch switch for example and rather than snap the throttle shut when the accelerator pedal closes you cut fuel injection and hang the throttle open to keep the turbo from slowing down. This is a pretty complicated trick to play though as if it got stuck in that logic you would have engine runaway and you want to make sure the engine RPMs actually fall at a reasonable rate instead of rev hanging badly.
    • What sort of power difference do you think you'll see between the two engines? Is it just the extra RPM from the wide journal that you're chasing?
×
×
  • Create New...