Jump to content
SAU Community

Recommended Posts

Hi fellow members i got my 180sx for sale, been out of rego for over a year so will require a blue slip to put it back on the road, i was only going to use it on the track, has clear titles and never been defected.

Engine Bay / Running Gear

Sr20det Blacktop

Fully built motor

Aria pistons

Eagle rods

Arp main/head bolts

Greddy Trust 1.2mm head gasket

Greddy 264 cams step 1

Greddy cam gears

Greddy rocker arm stoppers

Greddy Trust sump

Greddy Plenum

Greddy Trust TD06-20G 8cm

Greddy Trust External Gate

Greddy Trust Manifold

Greddy pulley kit

Greddy Swirl Pot

Greddy oil cap

Greddy Air diversion plate

Greddy Intercooler kit

URAS engine mounts

Tuneagent oil block

Oil cooler kit

Spit fire Coil packs

K&N pod

Sard 740cc Injectors

Turbosmart Fuel pressure Regulator

Bosch 044 pump

Koyo aluminium radiator with thermo fans

Nismo Thermostat

Aluminium overflow bottle

Full exhaust with twin pipes

Cusco brake master stopper

Drive Train

VLT MX-7 rb30 Gearbox Housing

Rebuild with Gtr gears ( Purchased as is )

SR-RB Cut and Shut bell housing

Hardy Spicer one piece tailshaft

Custom dogleg shifter in factory position

Exedy Clutch kit

s15 diff with Cusco 2 way LSD

Interior

Genuine Bride Low Max 3 drivers seat

Genuine Bride RH rail

Copy bride ergo 2 passenger seat

Genuine Bride LH rail

Genuine Nardi Flat 330

D1Quick release

HKB Boss

Safety 21 8 point cage

Drift Buttom

Trust Gear Knob

Relocated battery to in cabin

Ecu / Electronics

Apexi Power FC D-jetro

Greddy Profec B 2 boost controller

Greddy turbo timer

Defi control unit

Defi boost

Defi water

Defi oil pressure

Defi oil temp

Body

Genuine type x front bar

Genuine type x lower lip

Genuine type x side skirts

Genuine type x rear pods and valance

Genuine D-Max wide rear guards moulded in

Genuine D-Max wide front guards

Standard bonnet with D-Max Vent

Type X tail lights with carbon centre

2up's carbon roof spoiler

Wheels

Work SSR SP1 polished

Rear 18 x 9.5 + 18

Front 17 x 9 + 16

Rays Blue wheel nuts

Brakes Steering and Suspension

Front

Ultra Racing 3 point fender brace

S15 5 stud conversion

S15 callipers with slotted rotors

Braided brake lines

S14 LCA with Tuneagent RCA balljoints

DriftWorks Geomaster 2 Knuckles

DriftWorks Offset steering spacer

Tein Tie rods with heavy duty Tuneagent ends

JIC Front coilovers with Camber tops

Nismo Power Brace

Cusco Caster Rods

Cusco strut brace

Rear

R33 5 stud conversion

R33 2 pot rear calipers

R33 drum handbrakes setup

Slotted rotors

Braided brake lines

JIC coilovers

Cusco Toe Arms

Tuneagent camber arms

Tuneagent traction arms

Tuneagent subframe spacers

Cusco Strut brace

Price $16000 ono or swaps for something of interest

can also lower the price further with the removal of parts

Location: Sydney Parramatta area

post-55425-0-52905800-1369559795_thumb.png

post-55425-0-02506300-1369559818_thumb.png

post-55425-0-21945500-1369559832_thumb.png

post-55425-0-69522100-1369559848_thumb.png

post-55425-0-03986000-1369559861_thumb.jpg

post-55425-0-51693200-1369559876_thumb.jpg

post-55425-0-77559100-1369559887_thumb.jpg

post-55425-0-39003800-1369559900_thumb.jpg

post-55425-0-74900400-1369559911_thumb.jpg

post-55425-0-07195100-1369559924_thumb.jpg

post-55425-0-94225500-1369559931_thumb.jpg

Link to comment
https://www.sau.com.au/forums/topic/425885-180sx-with-a-heap-of-fruit/
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Yeah, sort of blurring two different things together, aren't we? I just meant O2 feedback closed loop. I used to have a 0-1V LCD meter on my dash, wired directly to the O2 sensor signal. So you could easily see what it was doing. Normal running it would flick back and forth nicely. Slow down to an idle and it would keep flicking, as the ECU tried to servo to maintain stoich, but it would slow down as each swing happened until it would stay at one end of the scale. As I said above, the sensor heater is not enough to keep it hot enough when there is also little heat in the exhaust flow. Give it a blip and it would start swinging again, then peter out again. Meanwhile, idle speed control would run just fine, because unrelated.
    • It's not even O2 feedback, it's just simply when the ECU sees the closed TPS signal for whatever reason the idle will start steadily dropping until the engine dies. With the TPS adjusted to not trigger closed TPS it will idle at some ridiculously high RPM and something like 6 degrees of timing. In the absence of getting eyes on it personally and a lot of quality time doing diagnostics I couldn't tell you what the real problem was but it was interesting nonetheless
    • Oof. One of my mates has an R34 GT-R that he initially was a "I want to go twins for response and convenience" on his stock 2.6 with Kelford 272 cams, but his friends are pests and were always in his ear about their place being in the bin.   Eventually one of the 2860-5s decided to add it's own input and force his hand, so he conceded and went for a Pulsar 6262G ("G35 900") with T4 0.85 hotside.    Here's an overlay of the results, same cams, same stock bottom end, same boost, same fuel, just from a pretty tidy 2860-5 install to a Pulsar turbo on a 6boost maniifold on BP98.   Worth mentioning here, it may seem like a dead horse thing but the dyno plot doesn't tell the story of how much better it is to drive - transient response has completely changed the car, he used to have flat foot shifting to stop it having to wind up again on gear changes even at >7000rpm... now it builds boost faster than that even short shifting.   It's 100% transformed the car before you even consider how much better it holds on: Pulsar and Garrett aren't the same, but from our experience if you're just looking for a better drive and the ability to make the same or more power I think the divided G30 770 would probably be the smallest I'd go to.
    • Great work Duncan, any events local you will give it a test once all done? 
×
×
  • Create New...