Jump to content
SAU Community

H K S Suspension With A Host Of Question Marks - R32 G T R


Recommended Posts

$100 buys you HKS Suspension from my car that I've never driven. Isn't that a puzzle?

Terry-60_zps12df8cfc.jpg

My BNR32 is still going through compliance and I've never driven her. This suspension has now been replaced.

Terry-64_zpse11794a5.jpg

So this set is a bit of a lucky - or unlucky dip. These could be worth a lot. But if they're 20 yrs old, they could be worth very little. Treasure or Trash?

Terry-63_zps49feb4b1.jpg

Yes, there's been surface rust through the car sitting outside.

Terry-62_zps741a5051.jpg

I can't detect leaks. The wetness is purely from WD40. Rubber boots are in good nick.

Terry-61_zpscacd69f7.jpg

The compliance centre said that the car rides fine without cap slap. Progressive springs helped. Probably for street, but not sure about track wk.

Terry-36_zpsc2e1370c.jpg

This is how the car sits with them > tyre wear has been even across the tread.

Pick up from Lower Blue Mtns thanks.

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share



  • Similar Content

  • Latest Posts

    • So latest update. I replaced the ignitor with a jspec unit from enjuku. It felt a lot better at first although it is a little bit cooler of a day than it has been. Warming up didn't have as much misfire sputtering as before. Went on a 10m test drive. Felt good, a lot stronger though I was taking it easy on the boost. On the return trip started getting the cutting out at higher rpm again and was getting worse the longer I was driving. Took it easy the rest of the way home. Before turning the car off was getting the normal idle sputtering I was getting before.  So where I'm at now, entire ignition system has been replaced with upgraded components. Plugs still gapped at .8mm. Removed the fuel cap in case it was building too much reverse pressure I'm the tank, didn't help at all. Now I'm still on the same tank of gas the fuel treatment was in, I'm thinking if I can run that out and then refill with fresh 93 maybe  the treatment is too concentrated in some areas but doesn't explain that it only does it once the car is warm. I'm leaning towards fuel pump or injectors but if the injector was clogging I don't think it would make it shut off like it has but then fire right back up like nothing happened. So my current guess would be the pump. Without a fuel pressure guage no way to test or check it while it's running.  So that's kind of where I'm at. Need to start testing fuel components and ecu/wiring but I'm at a loss of what's the next logical step and procedure for testing it. 
    • @niZmO_Man thanks for that info, lucky I bought the gktech ones 🤙.
    • Never cheap out on brakes, tyres, suspension. I learnt the hard way at Oran Park lol
    • You got your answer when everything was OK after disconnecting your return line from the FPR. Why in the world are you running a 460, 2200CC injectors, etc. on stock 8mm lines?  Keep the pump, ditch the lines. I used both 8mm lines as my feed and one of my Hicas 10mm lines as return. 
×
×
  • Create New...