Jump to content
SAU Community

3" 5 point Harness

Recommended Posts


2 x TRS 3" Five Point Harnesses

These are red with ROTARY BUCKLES, includes CRUTCH STRAPS.

These are FIA Approved, date stamped "2003" hence are "out-of-date" for rally or other motorsport use, however would be fine for street use.

These belts have never been crashed and never exposed to UV light for extended periods of time (car always garaged). they were only used for 2 seasons of competition and are as good as new - the only reason i am replacing is that the regulations do not allow for competion use past their expiry date.

Offers around $350 for the pair ($1000 New).. will ship anywhere in Oz.

Photos available on request.



Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

  • Similar Content

  • Latest Posts

    • >complete amateur >1:24 at Winton laggy massive HP RWD R32 I dunno about the first part I would argue this use case probably doesn't need VCT, won't be in the rev range that it would ever be active!
    • Last weekend I changed out the noisy bearing in the rear. It went fine except the axle was super stuck in the hub. I eventually got it all swapped out over two days. The car is so much quieter but the ABS light came on. I freaked out thinking I'd put the bearing in backwards or used one without the integrated magnet for the speed sensor (lower E90's use a ring attached to the axle rather than built into the bearing). I checked the 2nd bearing I got, seems I got it right (black side in first). I bought a new Bosch speed sensor from eBay which arrived today, 10 mins to fit and cleared codes. No more ABS light.  My gut says I probably damaged it when pressing the bearings in and out as it kinda hangs in a bad spot - i should have removed it. Anyway, whatever, its quiet and fixed. I think the front bearings are ready for changing now, I can hear very slight noise that would have been masked by the dead rear one. Front ones are bolt in thankfully. Also bought the Nolathane rear subframe bushes and a Whiteline 16mm rear sway bar (OE is 13mm). I had this bar on my 330i but cbf'd removing it so just got another. The subframe needs to be lowered to fit the bar so i'll do bushes and bar at the same time. I was really temped to get solid aluminium bushes but they are really expensive and the whole subframe has to come out, not just be dropped which is not something I'm keen to do. 
    • who'd have thought and  some compression 🤔
    • Nice car! Looks like a good base for "restomod"ification. 👍 My first (and to date only 😔) Skyline was an HCR32 2-door so a big fan of these.   
  • Create New...