Jump to content
SAU Community

Rb 2860-5 Highest Hp?


Jc052685

Recommended Posts

  • 8 months later...

We took the car to the track. The car got stuck in safety boost some how. Also ended up killing the front diff. Customer does not want to go back to the track yet and risk hurting the car again.

 

Edited by Jc052685
Link to comment
Share on other sites

  • 3 years later...
18 hours ago, Torque Curve said:

Has there been any good modern setups with twins lately??

 

So far the only "modern" twins setup that I've seen which has generated a result which gets one thinking is the PMC/Integrated Motorsport R34 GT-R which makes >1100hp @ crank on G25 660s.  It's laggy as hell, but has a wide (like 6000-10000rpm?) power delivery so there is a bit of a swings and roundabouts thing going on there - you would NOT use that for what most are looking for with twins, not least because it's not stock location but instead some wild fabrication involved.  I don't expect there to be any major development with stock location twins as turbo tech isn't really the primary hold up, it's mainly packaging limitations imho... which is a lot of why I'm so pro-single on an RB.


BTW, this thread is hilarious to look back over.

  • Haha 2
Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Latest Posts

    • I disconnected before the fuel pump and restriction still there. Disconnected at turbosmart fpr and also after ethanol sensor and pressure dropped. No kinks in line but I found one spot above diff that I can hear the fuel flowing while running so I'm wondering if there is built up corrosion  from 10 years of sitting.  I had injectors cleaned and tested and one was dead but rest were fine. Was never an issue when I owned the car previously but I'll talk to jez about his thoughts on if they should be changed to newer tech. Thx guys at least I know the setup should work again. Pump is wired directly to relay and not using factory plug any  more 
    • Nice work on the shroud/ducting.  
    • Hi and best of luck with your car. Its a bit hard to tell how low the car is all round from that pic or if its been lowered or not. 90mm is a bit low on the front apron but it depends on the shocks & springs condition & whether or not its been lowered. Going to 19” wheels will give you 15-20mm depending on rubber but you might need new shocks. Mine -2005 are weeping fluid slightly but have lasted 19years!!. So if yours are original they need replacing anyway if they havent been touched before.
    • Hi everyone, Recently got handed down a 2004 Skyline 350GT Coupe. I would like to change the wheels as the previous owner installed some weird ones. The current ones are 215/45ZR18, unsure of the offset, and sit pretty deep in. Would like to increase the ground clearance slightly as well as I need to get it roadworthy standard, currently sitting at 90mm. Was thinking that maybe I could kill 2 birds with 1 stone by getting new wheels.  Pictures of current wheels: https://imgur.com/bg1QMIu Any recommendations for the types of wheels I should be on the lookout for? Like the maximum and minimum offset, sidewall height, width, etc.  Sorry in advance if I'm noob, I do not know much about cars other than how to change the oil, a blown tyre and brakepads....
    • Hey MinKer, Where abouts did you get that table from ? 
×
×
  • Create New...