Jump to content
SAU Community

Valuation of r33 gtst 1998 40th anniversary


Recommended Posts

They just look like regular mnp s2 gtst no 40th anni gtr wing or 40th front bar. 20k seems a bit rich.

Also FYI not all MNP 40th's had MR bodykits as stock standard factory options.
Out of over 65,000 RB25DET's build from Series 1-2.5 only 178 came out with Factory LP2 Midnight Purple.
ALL the MNP's were 40th Anniversary Series 2.5 only.
135 Manual
43 Automatic

So my car is 1 of 43 only ever released.

I consider that "rare" & been told this.
I'll be selling mine soon while she's a low km stock car.
I don't really want to sell but I need to pay bills.

For more information you can see here on the gtr website registry.
The 40th Anniversary's were even rarer than MNP GTR's. They made almost 1,000 MNP S1 GTR's!

Gtr Registry Website Link Below:

http://gtr-registry.com/en-ecr33-vin-table.php

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share



  • Similar Content

  • Latest Posts

    • Y'know what, after reading a topic on a 360kw build using a nistune (who ended up going LINK), im now considering a LINK over a nistune. The engine protection alone would probably be worth it. And id like to learn to tune so would be nice to have that safe guard. Which means i probably wont need a boost controller then, or the R35 MAF.  Becoming a bit of a blog now but oh wells. As mentioned previously, the goal is around 300kw, for a daily driver. Will be looking at fitting a highflow turbo or similar (something that doesnt require downpipes, manifolds etc to be changed out) when the current stock gives out or the money for it is there. 
    • Thanks guys. Are you meant to tighten the converter bolts through the starter motor hole? Think my plate between gearbox and engine is one piece. Im heading up there tomorrow.
    • Picked my tailshaft up yesterday arv!! Test fit it and because they've gone to a ford centre bearing and CV I had to modify the mounting bracket a little bit. 5mm of each side and she went up into position and fits well. It has a 1350 uni and flange on the gearbox end so it should be plenty strong!  Got stuck in this morning and started on the wiring mess. Cut out all the wires not required that go to the body connector and cut the engine harness out. Need to go through and work out which ones I need to keep and rewire into the new ecu. Should save a small amount of weight as well. I'd love to get in and rip the dash and everything out to completely remove wiring but cbf.  Next up was the power harness for alternator, starter etc. It has a few connectors from factory that run out of it. Cut it all apart and removed what was no longer required and put some new corro and taped it all back up and bolted it all back into place.  After that I worked out where I can mount the new flex sensor. Found a couple of factory bolt holes and drilled a new hole on the bracket to suit. Need to go get a few fittings and adapters tomorrow so I can keep going.   
    • Nah, im after the more newer looking, one with the OLED display
    • We revised the neutral wire instructions. The old way was wrong.  R34 gearbox change.pdf
×
×
  • Create New...