Jump to content
SAU Community

R34 GTR diameters of -Front anti roll bar -Rear anti roll bar -Steering rack mount bush -Front tie bar to chassis


Recommended Posts

Hello,
 
Since all my bushes start to die, I found strongflex be a good replacement :
 
I have a r34 gtr 1999, I want to buy this kit however I don't have the car this week and I can't check the diameter of :
-Front anti roll bar
-Rear anti roll bar
-Steering rack mount bush
-Front tie bar to chassis
 
Can you advice me the corresponding diameters to match with my car ? I can provide more info on it if needed
 
Thanks for all
Link to comment
Share on other sites

10 hours ago, KiwiRS4T said:

The suppliers seem to have it sorted. Just tell them its for an R34 GTR and it looks as though they can supply the correct parts.

I also asked but I wanted an other source to confirmed so that I will not have any surprise when I will changed them.

so if anyone can give me some info that would help me a lot?

thanks for all

Link to comment
Share on other sites

Well I'm sorry I just spend a couple of hours looking for the OEM sway bar fromt and rear but I found different answers ....(I do find for upgraded parts)

So I guess I will measured them this week end.

 

Could you at least point me out for the diameter for the steering rack ?

Strongflex can't help me ...

thanks for your time 

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share



  • Latest Posts

    • Because it's rubbish, it got progressively better with each generation but still rubbish when you're pushing the car on the track. Some like it, most hate it.
    • Yeah, I presumed that the pic was of some other car, because of the F. Ikeya arms.
    • Did a little bit this afternoon and pulled the dump and turbo off so I could take the mani off to clean it up and give it a few coats of paint. Wire wheeled what I could get to and then got the sand paper out to get the tight spots. Gave it one coat so far, will do another two tomorrow and see if I can fit it in the oven to bake it for an hour along with the adapter and dbw.  Hoping the exhaust wrap I ordered turns up soon so I can wrap the dump and screamer. Ordered 30M so I'll wrap back as far as I can to help a little with temp next to the box and also the floorpan. 
    • Yeah I think overall I’m running the expected power I should be running for now and I’ll just enjoy it for the time being until I get some other parts. Thanks for the advice mate I appreciate it!
    • That's fair enough.  Might be time to just enjoy what you have until you sort the ecu/flex sensor situation. You can pretty much guarantee that you are knock limited and e85 is going to be the solution to more power. 
×
×
  • Create New...