Jump to content
SAU Community

Recommended Posts

Wiper motors , front n back

Starter Motor

Apexi N1 cat back exhaust

Passenger side door with mirror and all internals (no inner trim thats all)

complete set of ADR approved seatbelts

Series 2 AFM

Complete diff, tail shaft and hicus setup

Stock suspension, front n back shocks n springs

Back seats

Rear windscreen

fuel tank

90% of inside plastic trimssome frnt most rear

Boss kit for sports wheel

ALL ITEMS READY TO GO AND ACCEPTING OFFERS

Link to comment
https://www.sau.com.au/forums/topic/58397-r33-gts-t-bits-n-pieces/
Share on other sites

I'm after the plastic clip that locks down the centre console lid (the thing you rest your left elbow on).

Haha - I'm after the same bit. I think I'm gong to get a bit of tin and bend it to provide the resistance needed.

haedake - Do you have the standard gear knob? If so what nic is it in?

Haha - I'm after the same bit.  I think I'm gong to get a bit of tin and bend it to provide the resistance needed.
A few people have told me to just glue a bit of small plastic to the underside of the actual lid so that when you push the lid down the extra plastic bit forces the clip to push down and lock.

Quote:

Originally Posted by benm

I'm after the plastic clip that locks down the centre console lid (the thing you rest your left elbow on).

Haha - I'm after the same bit. I think I'm gong to get a bit of tin and bend it to provide the resistance needed.

haedake - Do you have the standard gear knob? If so what nic is it in?

sorry guys no center console rooftop

and tow truck drivers stole gearknob...dirty ****s

everyone else check pm's

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Yes the gear for the R33/34 is different, it is red and has a different number of teeth. My part didn't come with that gear though, so I don't know how many teeth are on the red one. You'd have to reuse the 260RS/R33 gear, as long as it's not destroyed.   Haha, as unfortunate as that might be it was working fine for about the first 1500km I've had the car for now.
    • Update all   thanks to the workshop manual, it lead me back to checking fuses as mentioned central locking and door open lights worked when acc was switched on. diagram attached shows two points of power 1. ACC and 2.  Batt with the later being fused (#28) I did check the fuses using a multimeter but I must have stuffed that up also. Went back and checked the batt fuse in interior fuse box and you wouldn’t believe it… a blown fuse. replaced fuse and everything is now working as it should including the climate control   thank you all with your positive insight and knowledge.    
    • Where is the warning "That this thread is super old"   I just went into a 5 year old thread, went to do a reply, and couldn't see anywhere obvious a warning of it being super old
    • Duncan is correct. Pitwork (and Toyota's own cheap brand "Drive Joy") were primarily created as brands to sell other manufacturers car parts. It would be weird if Nissan sold parts for Toyota vehicles with a Nissan logo on it, so they created Pitwork to sell parts for other brans Toyota, Honda etc. They are not the same as Nissan genuine parts, although they *do* meet Nissan's standards for replacement parts. They aren't supposed to be a substitute for genuine parts, but a cheaper alternative that is better than Ebay fake parts from you-know-where.
    • Thanks GTSBoy, much easier to work with it now it's free!  
×
×
  • Create New...