[R32 Gtr 2Wd/4Wd Switch]

yep, but the computer needs to "reset", so even when you flick the switch while moving, you will need to come to a complete stop for the wheel speed sensors read 0 speed. Then it will reset and the lights on the dash will go out and you will have 4wd again

[Cant Set Boost Very High With Blitz Spec R]

nope, ive had a far play about with it. i have adjusted the gain up to 27 at the moment without any spiking.

the boost setup on the controller was on 50 when i started playing with it and was only running actuator pressure, 13-14 psi.

so ive been adjusting the setting from there up to 96.

but strange, like its run out of range.

i was thinking some different actuators would help, but i would think this unit would do better than this

[Removing R33 Gtr Boost Restrictor]

if you buy a turbotech, they come with simple instructions in laymans terms just follow them. The boost contorllers are cheap and work well i think.

[Cant Set Boost Very High With Blitz Spec R]

Hey guys, I just swapped out my turbotech bleed valve for a blitz dual solenoid ebc spec R

Everything is working as it should, except, i am up to 96 on the boost control.

The boost control goes from 0-100 so its nearly maxed out.

At the 96 setting its sitting on 1.3 bar quite consistantly, I really want to be able to use over 20psi, or 1.5-1.6 bar.

The way its looking it will only go to 1.35 bar max at 100 set point.

car is R32 gtr

stock engine

jun 264 9.7's

-5 turbos with stock 14 psi actuators

Hpi dumps

twin 3" into full 4" system, no cat, one straight through muffler/cannon

With the Turbotech setup i did have boost above 25psi for a while, so the turbos and support gear are fine.

Anyone else experienced this problem?

[Bosch 2200 Rb26 Install]

There is one wire into the resistor pack a 12 v supply, then 6 outputs, the 6 outputs go to the injectors, basically if you join all the 7 cables togethor you will have bypassed thr resistor.

[99 R34Gtr Vspec, Now Stroked!]

What are you looking to do with the intake piping to the turbos and outlets? You keeping the stock look, with air box etc. nice build by the way, good looking Gtr.

Also where did you purchase -5 rear housings as seperate items?

[Rebuilding Front Diff]

not sure why i have this seal, dont really need it to do the diff, lol

seal hub front...- 40227-50W01

[Anyone Using A Quaife Diff?]

Diff arrived, Palmside were good to deal with, Bought for less than 1k delivered in the end, bargain in my books.

pics

and all new bearings to install

BBQ, oil and liquid nitrogen used to get the bearings on and cups in the diff

[Rebuilding Front Diff]

sorry for the late reply, but here you go

[Rb26 Air Temp?]

If you wish to play with the PFC your self, Datalogit is the go, I tune my own car and its very easy to use.

[Rb26 Air Temp?]

Thats correct, you will need to use Datalogit to change air temp correction values, so yes they can be changed, but not with the hand controller.

[Midori 80Mm Sus Front Pipes R32/r33/r34]

I own the same exhaust front pipe, by the pics it looks genuine to me. Looks identical. Well built unit.

[Ku36's Anyone Got A Decent 60Ft Time With Them In A Gtr?]

Once they slip its all over

This man speaks the trufe

[What Wheels Look Better On My Gtr?]

I like the 19" wheels better,

a small drop in ridre height, maybey 20mm would really finish them off,

to remove the big wheels roller skate look.

[Extended Sump To Suit Rb26/30 In A R32 Gtr]

hi octane and trust are common sump extensions, cant comment on first hand experience though

[255/40/17 Tyre Options]

Federal 595's cheap and perform fairly decent, is what I have.

595 evo's come in 255/40/17 ??

[Powercruise Perth 2012, Who's Going?]

i'm heading down from Kalgoorlie, wont have my rig running though, diff and various bits pulled apart for an upgrade.

will be good for a look either way, hopefully catch up some sau guys

[Pro Sport Gauges]

have you looked at the HPI gauges, always advertised in zoom magazine and the like, they look good, anyone used them?

[Anyone Using A Quaife Diff?]

ok I have done some shopping about, decided to go with the quaife unit. ended up ordering it through palmside nz, should have it in one to two weeks

[Paint Job On My Gtr]

hmm, i have the code, but its not model specific, ive been told it was a subaru colour originally, not sure its true though, i cannot find any cars in the same colour, but thats kinda cool.

[Paint Job On My Gtr]

mine in blue, its not a standard colour, but good for a reference

[Anyone Using A Quaife Diff?]

Good question, I can get one for 1699 delivered from just jap. Anyone know a better dealer?

The quaif diff sounds awsome for street and circuit work, anyone know what it wo be like launching at the drags?

[Anyone Using A Quaife Diff?]

Good question, I can get one for 1699 delivered from just jap. Anyone know a better dealer?

The quaif diff sounds awsome for street and circuit work, anyone know what it wo be like launching at the drags?

[Where To Get R32 Gtr Wiring Diagram]

i'm looking, some wont open though...

i think my computer is going to die, lol

[Rebuilding Front Diff]

I just bought all bearings and seals to rebuild my front diff. They arrived today. I'll get all the part numbers for you of you want.