Jump to content
SAU Community

Bride Seat - Old School (Dark Purple With Black Centre)

NATAS

By NATAS,
in Wanted to Buy

 Share

Recommended Posts

NATAS Apprentice

NATAS

Posted
Posted

Hi all,

I imported my car with a single Bride bucket a while back, it's the old school type in the traditional purple trim / fabric material with black centres - most that I've come across has the grey centres where the multiple 'BRIDE' logo is, mine has the black centre. I'm after another one to match the one I've got, It doesn't matter if it's fixed back or reclinable (reclinable preferred tho) as long as it's in good condition with no damage. I'm willing to pay up to $500 as long as the condition warrants it. I'm after another one of this type instead of getting another matching pair altogether because I KNOW these ARE genuine BRIDE and not some Taiwanese copies.

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • GTSBoy
      Can anyone shed some insight on this Turbo?

      By GTSBoy · Posted

      Just that it's smaller than the "best" choice out of the available options.
    • r32-25t
      Can anyone shed some insight on this Turbo?

      By r32-25t · Posted

      Never heard any declare the -9 as a waste of time 
    • Duncan
      R32 GTR fuel gauge not working despite fixing fuel level sender

      By Duncan · Posted

      BTW, level up linking and @-ing, thanks David I actually don't have much to add, except that I have seen electrical gauges "off the scale" due to some sort of mechanical issue that work properly again after freeing up....sounds like that might be what happened here...
    • Sean'O
      3D printing fun

      By Sean'O · Posted

      Howdy all, A mate of mine picked up an R32 GTS-T recently and it had a very... colourful... gear knob that needed to be replaced immediately 🤣 I put together a replacement which is reminiscent of the Nismo offering, which I also really like both the feeling and design. I basically took what they did and optimising for 3D printing, with the exception of the top chamfer, where I prefer a filleted design, despite it not printing quite as clean. If anybody needs another thread size for the locker or if you prefer a top chamfer similar to the Nismo one, I'm happy to put something together for you and as a side note, I was really impressed by the TPU lock nuts. Originally I was going to use steel and then found out the ones I had on hand were sadly M10 1.5 pitch, rather than the required M10 1.25 pitch, so I had to get a bit creative rather than wait for the bolt shop to open. In the picture it looks a little bit 'rough' at the top due to the layering printing on a curve, but in reality it's not very noticeable at all and honestly feels pretty good in the hand. https://www.printables.com/model/910138-nissan-skyline-r32-gear-knob Regards, Sean
    • GTSBoy
      Can anyone shed some insight on this Turbo?

      By GTSBoy · Posted

      Which can be translated into English as "waste of time"/"good"/"too big"/"stupid".
×
×
  • Create New...