iam_dominic

PM sent

Yeah its not really important..just something that i noticed in my engine bay that wasnt sure about. Thanks

Any idea what this copper pipe is...? oil...water??? its located just to left of the exhaust manifold. sorry about the bad picture quality (camera phone). Thanks

yeah i know. ... and its gonna cost $$$!! to do so. Any idea what the stock RB25DE injectors CC value, there smaller but by how much?? "RB25 uses side feed high impedance injectors 370cc" "N/A engines I have not included these but are generally smaller" http://www.meggala.com/injectors.htm

Ive been looking to do run oil/water lines without having to drill into the engine too. I dont have a digital camera on me atm but there is this copper pipe that looks like an oil line to me its located towards the left of the exhaust manifold (underneth the nissan lable printed on the head (looking at manifold which on my right). What do u reckon... is this an oil line?

Sweet thanks NA_R33... i reckon! an 1.6mm HKS $632, 2mm HKS $690.. Looks like i will be sticking to high compression / low boost

how much would a thicker headgasket set us back?

I have all ready brought a heap of parts so i wont be buying an 1/2 cut. I have: *Exhast Manifold + Turbo (no lines) + Dump + Frontpipe *Stock intercooler with piping () ..a few picutes might help me with the assembly *GTST ECU So do i just need injectors/ turbo oil and water line now? Ive been suggest - replacing the head gasket with a thicker one to lower compression... reckon its a good idea?

i suppose but then i would need to buy an ECU from a RB25DET right?

hi ive beem motivated to turbo an N/A and i was wondering if changing the stock RB25DE injectors with the RB25DET injectors is necessary?

Doing a NA -> TURBO conversion and am looking for a stock front pipe somewhere in BRISBANE

my mono amplifier has 2 speaker slots: |+|-| |+| -| [ my visual diagram ] do i just simply connect each sub into an individual slot? coz my subs are both 4 ohm each, i need to connect them in parallel so i can get a 2 ohm load... in this case i would have only one negative (-) and one positive (+) wire to connect to the amp. Do i connect the 1 positive and negative wire into 1 speaker slot...looking like this |X|X| |+|-| (X where wire goes in) or do i use a separate one for each wire: |+|X| |X|-| Hope you can understand what im trying to say here

ok im attaching it to the System remote control wire... hopefully it will work and wont blow everything up on me thanks guys for ya help

i have a blue wire coming from the HU with a tag attached to it saying "System remote control" and theres also a green/red wire thats the "power antenna up/down". which one should i connect the amps turn-on lead to?

In my amplifier instruction manual it says to connect the turn-on lead to the "power antenna turn-on lead" at the head unit. Any ideas which colour this power antenna wire is?

i have 2x 12inch alpine 200w RMS subs and am in need of a good amp to power both subs any suggestions?