Jump to content
SAU Community

Recommended Posts

Hey all,

Selling off my bride ergo as I need some cash for other things!

Has been out of the car for a fair while now and is in MINT condition bar a tiny hole on the drivers side bolster. It's really very small, and there's some slight marks around it from where I covered it up so it wouldn't get bigger, but a wipe down will get rid of those. You can see this in the picture.

No rail.

$600 - will trade on Recaro SPA or SPG only

PM or reply here

Dane

post-8405-1162766652.jpg

post-8405-1163296906.jpg

Link to comment
https://www.sau.com.au/forums/topic/141999-bride-ergo/
Share on other sites

Hey all,

Selling off my bride ergo as I need some cash for other things!

Has been out of the car for a fair while now and is in MINT condition bar a tiny hole on the drivers side bolster. It's really very small, and there's some slight marks around it from where I covered it up so it wouldn't get bigger, but a wipe down will get rid of those. You can see this in the picture.

No rail.

$600 - will trade on Recaro SPA or SPG only

PM or reply here

Dane

i have a Recaro seat that i wil be selling L8r but im not sure if its the model your after...

Link to comment
https://www.sau.com.au/forums/topic/141999-bride-ergo/#findComment-2653255
Share on other sites

  • 3 weeks later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • I don't care for these at all, but at least the underside looks straight and not rusty. A good basis for a long life. Many cars from Japan have been lifted with forklifts and f**ked almost irrepairably.
    • Yes, but it's not dumb or dodgy. You can build a perfectly good boost controller from a pressure reg, a relief valve (looks same same as a reg if all from Norgren or SMC, for example) and a check valve. I ran one for years. Only superceded with  EBC because I could get one for cheaps and wanted finer control.   THis mod is certainly not a sketchy boost mod, provided the boost is kept below the "spin to death" threshold of the turbos.
    • With ordering the belt, you're doing water pump and the idler and tensioner at the same time too yes?
    • This is just a dumb way of keeping the wastegate closed to make more boost. Undo it and either follow the factory setup or redo it properly. Manual boost controllers just use a spring preload to determine when to close in response to boost pressure so it no longer vents to atmosphere.
    • So for the wide band is a Bosch 4.9 correct for the Link G4+ along with a Can bus? Just get the Link gear or is generic ok too? Eg here: LINK LINK DIGITAL WIDEBAND CAN MODULE WITH BOSCH 4.9 SENSOR : KYP Performance House  
×
×
  • Create New...