Jump to content
SAU Community

Sold: Billion Racing Air Funnel + Juran Duct Pipe

nuffsaid
 Share

Recommended Posts

nuffsaid Veteran

nuffsaid

Posted
Posted

Hi all

I bought a CAI setup on my recent trip to Japan and SuperAutoBacs.

There is a Billion Super Racing Air Funnel, 75mm, clamps, stickers and everything. The box is unopened, it still has the seal on it. RRP 3150 YEN

I also have a Juran Air Duct 75mm diameter 1m wide to go with it. This is also still sealed in its plastic wrapping. This is proper duct piping that is strong and wont rip. RRP 3780 YEN

This will be a great setup for a CAI feed from the front bar to your air filter or box, JDM quality. You could also pipe so air to any other part of the engine, brakes, anything really.

$70 + postage.

Thanks

post-7128-1188105257_thumb.jpg

  • 2 weeks later...
  • 3 weeks later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Latest Posts

    • Songo
      New kid on the block

      By Songo · Posted

      Thanks MBS206, i got that PDF but got abit overhelm with all the connections and tracing of wires. I wasn't expecting to plug the dash harness anywhere. i was just going to use my electronics jumper wires to plug into the right pins like ECU power, ecu ground, ignition trigger etc... I do have a few ratchet straps locking it down tight. Fire extinguisher ready and only a small amount of fuel at a time, enough to submerge the pump.
    • Songo
      New kid on the block

      By Songo · Posted

      Thanks GTSBoy, i will do abit more digging. I am missing a blue relay near the ECU connector... so i will chase that up in the next few days as well  
    • MBS206
      New kid on the block

      By MBS206 · Posted

      https://yariksteel.ru/manual/R33/Skyline_R33_elektroprovodka.pdf   Page 18 should be what you want for the Dash Cluster wiring. Though, you don't need the dash plugged in to get the motor running. What you want is power as how GTSBoy said. You need to power the ECU. Find in the above link the ECU pin outs (Verify them before just connecting them up from things written on the internet). Find anything needing power, give it power, find anything needing ground, give it ground. Then give the starter motor power through a big cable, and bridge the solenoid on the starter straight to power too.  ECU will be on, and when you give the starter power, it'll spin the starter motor, and it should start. I also hope you have a proper stand, and not just the engine sitting on some wood. You will want it bolted down properly.
    • Cangorus
      New here

      By Cangorus · Posted

      Hello everyone, I am happy to join you.
    • Duncan
      New here

      By Duncan · Posted

      Whereabouts are you, that looks exactly like Akira's old car....
×
×
  • Create New...