Slide Stage 3 Hiflow

[sam5709]

hey guys

after having a few complications with my ITS turbo i bought i decided to suck it up and buy a stage 3 slide hiflow, now, i know you have to do some moding to the oil banjo bolt, and i have done a little search but am not 100% confident i know what to do.

would it be possible to just get enzed to make a braided line the same diamater as the stock line except get fittings that are bigger to accomadate for more oil? if i do get this done, what will i have to do about the oil restrictor?

if there is a thread with some more help could you please point me to it as i cant find any LOL

thanks

sam

[Tangles]

you will have to send a PM to Slide and ask for the link to the pictures that show what need to be done (ie how/where to drill out the banjo)

I went to enzed and got a new line made up, leaving them my old line and the instructions that I got from Slide, so that Enzed would get the overall diameter correct for the braided line

good luck with it.

[FineLine]

If you want to use the factory oil line you will need to drill out the restrictor with a 6mm drill bit. To get to the restrictor you need to drill through the "banjo housing" (the knuckle bit on the end of the oil line). You will then need to go to a radiator place (or somewhere similar) and get them to braise/weld over the hole in the banjo housing.

Lazy-Bastard

[sam5709]

ok kool thanks for the replies guys i just found thread with basically step by step process with pics and all