Jump to content
SAU Community

Recommended Posts

32 4dr rear seats . one small tear and stain $30

rear door covers no handles . ok cond $30

b piller covers . ok cond $20

c piller covers . bit bent $20

rear parsell shelf. ok cond $20

roof lining with sun roof cover. ok cond $20

2 door sun roof frame and glass (can fit in 4dr) . motor plays up $30

skyline rear centre mat , good cond SOLD

centre console .ok cond $20

new leathers gear and hand brake boots , good cond SOLD

Rear seat belts . good cond $30

Re-trimmed 32 GTR seats with rails $990

re-trimmed front door covers SOLD

qrtru3.jpg

qwertax0.jpg

carstuffgc182nh6.jpg

carstuffgc176wa4.jpg

carstuffgc177lj4.jpg

carstuffgc184rl8.jpg

PM me

cheers

Beau

Link to comment
https://www.sau.com.au/forums/topic/208427-32-4dr-interiour/
Share on other sites

  • 3 weeks later...
  • 3 weeks later...
  • 2 weeks later...
  • 4 months later...


  • Latest Posts

    • I'm with you here. It's either loom has an issue, OR, injectors are not functioning properly. It could even be they're just constantly dribbling, hence the wet, but not firing.
    • Depending on how long the car sat it is very possible for injectors to be stuck open or closed, I'd get them cleaned and flow tested. Other than that, obviously when the loom changes and the car doesn't start any more....the loom is suspect so some tracing / comparing may be required
    • Harness is for a s1 Rb25det, and it is engine and lower harness.  the old harness had broken off plugs and was in very rough condition/exposed wires and splices etc. it is not able to be put back on the car, I could visually inspect to see if they had rewired any pins on the ecu plug. The fuel pump definitly isn’t turning off it’s an external pump and very loud you can hear it. Will look at the other harness tonight, am also going to pull the fuel rail and watch the injectors spray, will update here with what I find. Pretty sure at this point it has to be something to do with injectors because car will fire up on starting fluid and cas is clicking the Injectors. Fuel pressure is steady 43psi 
    • Check the injectors flow evenly, and are actually flowing what you and the ECU think they should be flowing. If it's starting up on starter fluid, you have a fuel issue. Is it possible under cranking your fuel pump is turning off?   The harness you replaced, is that the whole engine harness? Do yourself a test, and drop the old harness on and plug it into the Z32 ECU. It's possible they've wired things different. From memory S1 to S2 is different in RB25 and you may have a wrong loom
×
×
  • Create New...