Jump to content
SAU Community

Recommended Posts

Hi everyone

Im getting rid of a Holden Gemini for a family friend. It has been with them since 1987. Details as follows.

1984 Gemini SL

Manual

290.000kms

Blue/Grey Colour

Rego until end of July '08

General Info:

It is far from perfect but has been a reliable car for over 20 years. The paint is is need of attention, as is the rear drivers tail light. Minor surface rust in the usual places associated with older cars such as in the boot sill area and slight surface rust on the roof etc. The engine leaks oil quite a bit and has been doing so for a while and not caused any problems so far. Tyres are fairly new with plenty of tread left on them. Interior is as expected, pretty old and dirty, with worn out carpet and so on. Its CHEAP!!!

Looking for $800 or offers

Located about 30mins south of Sydney.

Contact:

0400 379 599

[email protected]

PM

Cheers

Ben

Link to comment
https://www.sau.com.au/forums/topic/216649-1984-holden-gemini/
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Latest Posts

    • Yep, the closest base tune available was for the GTT, I went with that and made all the logical changes I could find to convert it to Naturally Aspirated. It will rev fine in Neutral to redline but it will be cutting nearly 50% fuel the whole way.  If I let it tune the fuel map to start with that much less fuel it wont run right and has a hard time applying corrections.  These 50% cuts are with a fuel map already about half of what the GTT tune had.  I was having a whole lot of bogging when applying any throttle but seem to have fixed that for no load situations with very aggressive transient throttle settings. I made the corrections to my injectors with data I found for them online, FBCJC100 flowing 306cc.  I'll have to look to see if I can find the Cam section. I have the Bosch 4.9 from Haltech. My manifold pressure when watching it live is always in -5.9 psi/inHg
    • Hi My Tokico BM50 Brake master cylinder has a leak from the hole between the two outlets (M10x1) for brake pipes, I have attached a photo. Can anyone tell me what that hole is and what has failed to allow brake fluid to escape from it, I have looked on line and asked questions on UK forums but can not find the answer, if anyone can enlighten me I would be most grateful.
    • It will be a software setting. I don't believe many on here ever used AEM. And they're now a discontinued product,that's really hard to find any easy answers on. If it were Link or Haltech, someone would be able to just send you a ECU file though.
    • Yes sir am asking is there possible way from aem tuner from wiring pins 
    • Have you checked cam to crank timing and confirmed balancer marks are correct?
×
×
  • Create New...