Apexi Safc

[niran]

Hey guys

I have just installed the Apexi Safc Version 2. I have read the manual and also checked out the DIY on this forum. I checked the pre setup settings such as the Sensors checks and all is working well.

I am getting the Safc tuned soon at all star garage but until then am i able to drive this car around?

I don’t know if this helps or not but this is the following info on the car:

R32 gtst with rb20det

Vg30det Single Turbo

FMIC

Turbo back exhaust

Stock Ecu

R32 GTR fuel pump.

I’m pretty sure I have done all the settings but may someone please confirm this.

The settings I have gone through and completes are the Sensor Check, Sensor Type(set at Hot wire), Car select ( cly set at 6, Thr Set at Up arrow), and the voltages for the throttle are set at in = 01, out= 01 , Sens. Cal in=1, out = 1.

That’s all i have done. Is this all right? And am i able to drive the car around without any problems to the ecu.

Thanks all help appreciated.

If anyone else knows any more settings i have to put in before i can drive/start engine let me know thanks.

Niran

[paulr33]

as long as you have the in and out set correctly

and you havent changed any of the correction

then essential the device, does nothing

so yes its fine

[niran]

as long as you have the in and out set correctly

and you havent changed any of the correction

then essential the device, does nothing

so yes its fine

Hey Man i havnt touched any off that and also did a Reset when i put the unit in as i got it second hand off another skyline.

Awsome thanks For your help

Tc

[Tangles]

time for a dynotune bud !!

good luck with it

6