Jump to content
SAU Community

Stickered!

syfon

By syfon,
in Western Australia

 Share

Recommended Posts

syfon Veteran

syfon

Posted
  • Author
Posted

Welshpool & O'Connor u can just rock up and have an inspection, but for East Perth, Warwick, Midland and Kelmscott you need to book.

The cops only have to find one thing wrong with your car to defect it, but then again the police do abuse their powers so your car doesnt really have to have anything wrong with it....

  • Replies 70
  • Created
  • Last Reply

Top Posters In This Topic

Popular Days

Top Posters In This Topic

Popular Days

Pal Veteran

Pal

Posted
Posted
this ruling went out about 3 years ago

ruling is now 1.25

ie:: r32 gtr stock runs 16 x 8 equates to 16x1.25 = 20 //// 8x1.25 = 10

therefore a r32 gtr can legally now run 20x10 rims

this was explained to me by Reno the head guy at welshpool pits when i got my gtr registered with 17x9's on it

so a gtst stock is 16 by 7 so we can go to 20 by 8.75 max legally. is this right?

Ehgriez Mentor

Ehgriez

Posted
Posted

stock gtst rims are 6.5 i think.

Im pretty sure the constitution leaves road rules to the states? Meaning that a national code of practise isnt going to be valid unless the states have forfeited their constitutional rights to govern this?

I got that info off the state site, its quite possible its outdated, but it seems odd it would still be up if it is.

IMPORTD Grand Master

IMPORTD

Posted
Posted (edited)

Maximum passenger car tyre and rim width

Tyres fitted to passenger cars or passenger car derivatives must not be more than 30% wider than vehicle manufacturer's widest optional tyre.

The rim width must not exceed the recommendations for the tyre fitted.

For example, if the original widest optional tyre is 185mm, the maximum tyre width is 1.3 times 185mm = 240.5mm, ie a 235mm wide tyre. The maximum rim width for a 235mm tyre is 9 inches if the aspect ratio is 60 or below.

NCOP11_Section_LS_Suspension_and_steering_3Feb2006.pdf this is downloadable from http://www.infrastructure.gov.au/roads/veh...n/vsb_ncop.aspx

Page 17 has a table to help. check it out.

Edited by StageaGirl
Pal Veteran

Pal

Posted
Posted (edited)

found it my guess is that it would be the 45 in 235*45*17

Aspect Ratio:

When buying a rim that is larger than stock, you must change the aspect ratio of the tire, too. This will keep your speedometer reading correctly. When you “upsize” your wheel, the aspect ratio will be smaller than stock. This gives your wheels and tires a wider contact patch, improving cornering ability.

Using a smaller than recommended Aspect Ratio means you have less rubber to absorb impact that can damage your rim. It also reduces the amount of contact your tires have with the road.

Using a larger than recommended Aspect Ratio increases the ride height, and will make your speedometer read slower than actual speed. It can also cause rubbing in the wheel wells. It affects steering stability, and will make your car feel floaty when cornering.

Edited by Pal
Psyrus Contributor

Psyrus

Posted
Posted (edited)
When is your car booked in at Joes Mr. Auto? I'll go to his shop and swap em over for the day :P

I'm calling him in a little while (just woke up... I'm a bit of a nightowl because I work late nights) to sort it out & I'll let you know.

I'm perfectly happy for you to grab em (I'll be dropping it as early as possible in the morning) as long as they're properly back on the car when I pick it back up :P

Don't want any of this lol

Edit: PMing you details

Edited by Psyrus
4NTM4N Enthusiast

4NTM4N

Posted
Posted

i got stickered yesterday in collie for my camber wear on my tires an they made me get my car towed back to bunbury at my cost of $250 i wasnt happy one bit,

does anyone know the rules of ride height might just take it to a dodgy garage an give em a carton :) jk

NISMOGTT Collaborator

NISMOGTT

Posted
Posted
i got stickered yesterday in collie for my camber wear on my tires an they made me get my car towed back to bunbury at my cost of $250 i wasnt happy one bit,

does anyone know the rules of ride height might just take it to a dodgy garage an give em a carton :laugh: jk

What is it with cops giving stickers now and saying tow the car... that is as good as a red sticker which have not been around for years and years...

I would like to know the law that says they can do this, as they are suggesting that you must now tow the car to the mechanics to get fixed and then to the pits before it is drivable...

ossie_21 Grand Master

ossie_21

Posted
Posted
What is it with cops giving stickers now and saying tow the car... that is as good as a red sticker which have not been around for years and years...

I would like to know the law that says they can do this, as they are suggesting that you must now tow the car to the mechanics to get fixed and then to the pits before it is drivable...

Technically they could only make you tow it if the wear on the tyres was that bad that it would be dangerous to continue driving. How bad the camber wear is depends on that, but in this weather maybe it could have been justified....

However to do that, really the yellow sticker should be timed & dated to when they write it up, leaving no other option but to tow it, otherwise they can let you drive off again, pull you over after 20m & fine you for driving with an expired yellow sticker ~$600....

Guest
This topic is now closed to further replies.
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • joshuaho96
      HR34 GT speedo issue

      By joshuaho96 · Posted

      Probably speedometer itself if the odometer is ticking. If the needle is stuck from a bit of grease or something that can cause it to stay at 0. Or a cracked solder joint in the speedometer can do it too.
    • Dylannn
      WTB RB25 Gearbox NSW / central west

      By Dylannn · Posted

      Thanks Fella’s   to take this off topic and to elaborate a bit more. I have an rb25/30 going into a r32 GTST.. expected to make around 600-700hp. Would you?   A) R34 GTT box   B) CD00#?  I’ve seen a few posts about the CD swap and sounds fairly involved with making it fit etc but if it’s worth the work then I’ll go that way
    • SeanR32GtSt
      Hypergear Turbochargers and High flow Services Development thread

      By SeanR32GtSt · Posted

      Lower at the hubs. Funny I forgot to mention that part. Do this pull here I turned the camera off too soon but the graph shows a drop at the top and that was because the pipe from the turbo blew off. The tuner said we could’ve made possibly another 15 whp. He also added if I switched to ethanol we could up the boost some more as well. I was comfortable capping it at the most of 20 pounds. Turns out the turbo pipe just needed a new worm clamp. Got home replaced that then did a third gear pull from 3k to 7200 rpm and the power was great to the top. I just got an ecu mounting bracket from IEE that I need to try and get everything to fit well. It’s a PITA to get the harness and ecu fit properly behind that kick plate 
    • GTSBoy
      R34 Manual conversion Speedometer

      By GTSBoy · Posted

      He means "as opposed to mechanical cable drive". Older cars (R32 for ex.) had cable drive. Later cars with essentially the same gearbox, ie R34 GT (NA RB25) used essentially the same box as the R32 GTSt, but instead of a cable drive, had an electronic speed sender plugged into the same hole in the box, running from the same little gear that would have run the cable. Some of the shittier later cars use a speed sender on the nose of the diff, or the ABS sensors.
    • GTSBoy
      Hypergear Turbochargers and High flow Services Development thread

      By GTSBoy · Posted

      Lower than engine, or lower than it should at the hubs? Either way, that is a nice power figure and I'm not surprised you say it rips now. What stopped you from turning it up any more? Injectors? Or did it just stop responding to boost?
×
×
  • Create New...