Jump to content
SAU Community

Recommended Posts

As topic states, I have the following for sale

Cobra reclinable seat. Excellent condition other than a few marks (Which would be easy to clean. No rail

$175

cobra.jpg

S15 front seats in immaculate condition. Rails have been modified to suit Skyline/Stagea but would be easy to swap back to suit Silvia

$350pr

S15seats1-medium.jpg

R33 GTST seats, front and rear. Good condition other than a small bit of wear on the driver seat. Excellent cheap upgrade for S13

$100 for the lot (not seperating)

R33seatf1-medium.jpg

R33seatf2-medium.jpg

R33seatr1-medium.jpg

Also a 15in Earthquake sub in sealed box. Excellent condition and pumps out alot of bass (too much for me)

$150

EarthQuake15-medium.jpg

Its only front and rear seats. Not whole interior. If its still here next weekend then you are welcome to it

yeah no worries... i would have to take out my seats then drive down to you on the weekends...

i'm in the parra area so bit of drive down to campbo...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Latest Posts

    • Oil change does not trigger code 21. Code 21 is for coilpacks primary side connection. You can try to clear the code with a battery disconnect, hold down the brake pedal to drain capacitors through the brake lights with the ignition on for 10-15 seconds before you reconnect the battery. I have seen R35 coil conversion permanently cause this code with no ill effects so it might be the resistance it wants to see isn't quite right on one or more coilpacks. Could be inside the ECU, could be the harness, could be a coil. You can test it all if you want or just ignore until the car actually starts misfiring.
    • I forgot you have a Nistune ECU. Use Nistune to do all the tests I mentioned instead of faffing with 30+ year old electrical connectors. You can read MAF volts off that too, there are reference values in the service manual to tell you roughly what it should be in different conditions.
    • No. I think it might be the AFM. Hence the use of the terms "swaptronics", which implies the use of swapping out electronics for the purpose of diagnosis. It's about the only way to prove that a small/niggling/whatever problem with an AFM or a CAS or similar is actually caused by that AFM/CAS/whatever. A known good item swapped in that still gives the same problem is likely to be caused somewhere else. They're all the same. Spraying AFMs with cleaner is an each way bet between cleaning it and f**king it.
    • Oh wow! This might actually work amazingly. Do you know the ratio of the diff? I was told the only thing you need to make sure of is if the front & rear diff ratios are the same. Ours is a 4.083 Thanks!
    • You think its the AFM? I know its a common issues on R32s. I find it coincidental how this issue raised right after cleaning the fuel system. As everything except the fuel system was fine before. I tried running it with the IACV unplugged but did not notice a difference and still stalled. However, the RPM gauge is not in the cluster right now, so I will need to connect the laptop again and use Nistune to check the RPM. I will check this weekend.
×
×
  • Create New...