Jump to content
SAU Community

Recommended Posts

My car has been running very hot for a while in between half and 3/4, i just recently got my radiator flushed and was told it was 85% blocked :flamed:

They also informed me at the time i needed a welsh plug replaced.

ANYWAY The car still seems to be running hot its not dropping any water now though.

Also how easy is to do a head gasket on a r32 could this be possible? i have checked and so far found no evidence.

Link to comment
https://www.sau.com.au/forums/topic/29104-im-worried/
Share on other sites

i'd buy a second hand or reco'd radiator and get the welsh plug fixed...

you can warp the gasket.... but i dont think your car is getting hot enough to do that.... but act on it asap cause the longer you leave it the more damage that can happen later... and the more you "get used to it"

Happened to my dad.... he found out the hard way ....Boom!!!!

$$$$$$ later reco'd engine. Goes better now!! (it was a Jackaroo)

Link to comment
https://www.sau.com.au/forums/topic/29104-im-worried/#findComment-598057
Share on other sites

yeah Pekatu thats normal

It should always stay at 1/2 no matter what. Any more and your in trouble!! I learnt this the hard way, i blew the head gasket on my last car and it cost me $$$

The stock gauge is fairly accurate, but an aftermarket one it will go up or down +/- a few degree's depending if you thrash it or just cruising...

Always keep coolent/water in your boot and if you ever see the guage go over 1/2 pull over before it gets too hot and see where a leak may be. Then top up your radiator and cruise your car to home/mechanics

Link to comment
https://www.sau.com.au/forums/topic/29104-im-worried/#findComment-598620
Share on other sites

You might want to take a look at ur thermostat. In other words buy a new one cause there not expensive. They have a tendancy to jam half open wich will cause your car to run hot. If it was the head gasket you would be using heaps more fuel that u usually do and there would be a lot of black smoke out the exhaust from richness. Worth a thought.

Cheers

Link to comment
https://www.sau.com.au/forums/topic/29104-im-worried/#findComment-599018
Share on other sites

How does a blown head gasket cause the car to use more fuel?

It will often allow water to get into the combustion chambers, giving white smoke out the exhaust, or may let oil in, with a bluer smoke out the exhaust.

Try the thermostat. If that doesnt work, do the waterpump, and make sure you bleed the system of air, there are bleed bolts (10mm head on my R31) on the intake plenum/manifold.

Good luck.

Link to comment
https://www.sau.com.au/forums/topic/29104-im-worried/#findComment-600072
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • So, I put my boat on a boat. First of all, I'm going to come out and say it. Why is Tasmania not considered a holy goal, an apex that all road-legal modified cars go to, to experience? This place is an absolute wonderland of titanic proportions. If people are already getting club runs for once in a lifetime 30 person cruises to Tassy then I've never seemed to see it. It is like someone replaced the entire place with an idyllic wonderland for cars, and all of the people living there with paid actors who are kind, humble, and friendly. Dear god. After doing a lap of almost all of the place I've found that it's a great way to find out all of the little things that the car isn't doing quite right and a great way to figure it all out. All in all, I drove for 4 hours a day for a week and nothing broke. I didn't even need to open the engine bay. This is by all means a great success, but it has left me with a list of things to potentially address. I also now have a 3D printed wheel fitment tool which annoyingly hasn't got any threads in it to actually assemble it. I might be able to tape it together to check the sizing I actually want to use, but it'll likely involving pulling the shocks out to properly measure travel at least at the front, and probably raise the car while I'm at it, at least in the rear. I scraped on quite a few things and I'm not sure how else to go about it. I was taking anything with a bump at what felt like 89 degree angles. And address those 10 other tasks. And wash the car. God damn it is dirty. And somehow, the weather was perfect the entire time - And because I was on the top of Mt Wellington it turns out it was very much about to freeze up there. I did something I typically never do and took some photos up there in what must have been -10 and the foggy felt like suspended ice, rather than mere fog. If you own a car in Australia, you owe it to yourself to do it.
    • Damn that was hilarious, and a bit embarrassing for skylines in general 😂 vintage car life ey. That R33 really stomped. Pretty entertaining stuff
    • Hi, I have a r32 gtr transmission. Does any of you guys have an idea how much power it will hold with the billet center plate and stock gearset? At what power level and use did yours brake with or without billet plate? Thanks, Oystein Lovik
    • Saw this replica police car based on a Mitsubishi Starion XX parked next to a 'police box' (it's literally a box) in Hirohata, Himeji City in Hyogo prefecture the other day. It's owned by Morii-san who is a local Mitsubishi Starion enthusiast. According to a local radio station blog post, he always wanted to make a police car himself based on ones he saw in his favourite Manga comics.  As it's illegal to modify a car to look like a police car and drive on the road, Morii-san tried many times to get permission from Aboshi police station headquarters nearby. They refused initially by after they got tired of that they granted him permission. However, the car can only be displayed on private property and obviously can't be registered as long as the police livery is present. The car was completed at a cost of 1.5 million yen (US$ 10,000) in addition to the car cost. A location was chosen outside Hirohata Police box where the car can easily been seen from the street. Morii-san has two other Starion road cars, both widebody GSR-VRs.
    • Ah coolant overflow, previous discussions make way more sense now lol. 
×
×
  • Create New...