Jump to content
SAU Community

Recommended Posts

1997 r33 gtst series 2

$8,500

5 speed manual turbo

heavy duty clutch recently installed

stock as a rock except for a kakimoto exhaust

interior is very clean with blue dash

rwc and rego availiable depending on prices offered.

used to have 19 inch mags but had bad tyre tread so replaced with stockies.

custom vented bonnet

cd player with speakers

all electrics are in good working condition

recently just had minor service.

This car is in excellent condition for its age and is mecanicaly A1. The interior is like new and it is a beautiful car to drive. I have owned the car for 2 years and am selling in order to fund an overseas trip i promised my gf.

Previous to me the only other australin owner was female, Oil changed every 5000km with synthetic oil. Trasmition just had full service and inpection for wear, and was given a clean bill of health

trying to upload photos but having a bit of trouble

post-46677-1279354666_thumb.jpg

post-46677-1279354772_thumb.jpg

post-46677-1279354857_thumb.jpg

post-46677-1279354874_thumb.jpg

post-46677-1279354885_thumb.jpg

Edited by ransom99
  • 4 weeks later...
  • 1 month later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • There's restrictor pills in the stock boost control hoses. That's how they set the amount that was bled off and hence the "high" boost setting. The usual mod in the day was to remove it and send the "high" boost setting up to about 14 psi.
    • Thanks Duncan, that's the best info I've read. Furthermore after learning about the PCM programming side controlling the factory boost solenoid, the purpose of the solenoid is to "bleed" boost when pin 25 is earthed, thus allowing spring pressure in the wastegate actuator to overcome diaphragm boost pressure, thus closing or reducing the position of the wastegate flap creating more boost as the turbo is able to spin faster. It's pretty cool to see a designated Pill to do exactly this, would have liked to have seen it with a tiny filter over the end for those moments in vacuum.  The constant bleed pill has now been removed completely from the system and solenoid boost control has been restored once again.   Case closed 😂
    • The wideband reading is meaningless if it's not running. Why are you using shitty old sidefeeds on any engine, let alone a Neo? What manifold and fuel rail are you using to achieve that? Beyond that, can't help you with AEM stuff as I've never been their ECU/CAS combo.
    • Manual boost controllers (where a little of the boost was bled off) were quite common back in the day, because they were cheap and easy. Generally they had a manual adjustment screw rather than being fixed like yours. Down side is they always bleed boost, not just when you want them to so an electronic boost controller that uses a solenoid will have less lag.
    • Hello , im new here and i have A31 home build  RB25det neo stock eng / turbo  aem ems 2 blue connector  aem 3.5 map aem cas disk aem wideband connected to ecu  355 lph pump 550 nismo yellow injectors side feed aftermarket regulator  and won’t start with base aem tuner basic tune eventually flipped cas 180 degree so it triggers on correct stroke not in exhaust cycle  Now it won’t start Wideband reads 10 and 11 at lowest fuel setting  and will share calibrations soon for aem tuner i think something is wrong in aem tuner    please if you have any information, am very grateful         
×
×
  • Create New...