Jump to content
SAU Community

Recommended Posts

Hi,

It's time for a change in rims..

For sale or swap

SSR SP1 Professors in Super black coat

3 piece rim

18x8.5 +30 215x40 Federal 595

18x9.5 +35 253x40 Federal 595

All tyres brand new

a few slight mark on front edge but hardly anything at all. Rears are perfect.

Located in Melbourne

[email protected]

0421 24 9000

Price: $2,600 firm. Or im considering swaps for r33gtr rims +cash my way. or let me know what you have.. do u like work xt7's, cr kai work vx ss

Have to be good offset for my chaser.

j5cne9.jpg

25qqkaw.jpg

Edited by HYPA13

Thanks mate

Phattt rims make any car sexyy

Please note: Now just considering swaps for 33 gtr rims nothing else. 1.6k cash my way

OR BUY the rims $2,600 firm

Edited by HYPA13

apologies offset price master.

not with new tyres moite!

Jap performance centre has them for 2650 with 18x8 18x9 +37 used tyres

Edited by HYPA13
apologies offset price master.

not with new tyres moite!

Jap performance centre has them for 2650 with 18x8 18x9 +37 used tyres

no need to apologise buddy just saying yeah import joint normaly do charge more .and there for they just sit around colecting dust but yeah rah rah rah ..good luck with ya sale nice rims thought

no worries.

ok last n final drop $2,500 otherwise i dont mind keeping these rims ive wanted for ages

only wanted to get some new coilovers as my car is 4wd looking.. but i think i must be patient n wait n slam it on these rims

***** someone please tell me why i cant edit my first post with price etc...

Edited by HYPA13

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Latest Posts

    • Thanks GTSboy. I will inspect the valves actually, is this something I can do while they are still in the head? The block/bores don’t look bad to be honest hey, I can still see the cross hatches in the bores and they still measure 86.5mm. I’m not sure how to measure the installed ring gaps but I will do that and take it to someone who can. 
    • I’ve had the same headache with my lowered car, scissor jack first then floor jack every time. Ended up grabbing an extra-low profile aluminum jack (about 70mm entry height) and it finally slides under the lip without drama.
    • No sync errors , i have installed AEM disk will return original 360 slot disk and check if there’s any one with running AEM disk could share setup 
    • Its been a while! Finally thought to do something on this car, so here we go. This will be a slow burning, multiple posts as I spend 0.5-1hr a day on this job, over multiple days... Full set of GKTech suspension arms!   Step 1: Buy Arms, done! Step 2: Start removing stuff. HICAS was easy. Rear suspension arms are now gone, they were a bitch but breaker bars with long handle extensions, 2 1.5hr slots later, stock arms are off! Next step, remove the hubs and take them to work to press out the bearings and bushings!  
×
×
  • Create New...