Jump to content
SAU Community

Recommended Posts

Hi,

Regrettably i have to sell my bike JUST IN TIME FOR SUMMER................. :|

Anyways, it's a cute bike, and it makes the rider look like he's packing the same size as Peter North. It is indeed the ultimate panty dropper.

It's in immaculate condition, and does mad skids in the dirt. Has one tiny dint on the tank (you can see it in the close up pic), but chicks dig the rough, masculine look.

I'm putting up for a reasonable $6500 NEGOTIABLE. It's in Sydney, so it won't be a mission to go pick it up. It is Learner Legal. I've done about 1800kms since i got it back in Feb, and has a grand total of ~9800kms on it. I've done the the 10,000km service on it already, so it's ready to go. Also, it has Rego til December.

It's stock except for the Pro-Taper handle bars, B&B Bash plate, and also has an optional kickstart (it's got electric start too). I've only been off road a couple times with this bike, that's why it still looks so fresh and so clean, clean.

Enquire through PM, or phone (0413 614 050).

And on to the bike pr0n:

5002309351_10ce35f6cc_b.jpg

5002914884_59c5f19fdf_b.jpg

5002914260_847c3a26f7_b.jpg

5002914556_afabc743e2_b.jpg

5002309969_88f7031b63_b.jpg

5002309671_f0715537a5_b.jpg

Link to comment
https://www.sau.com.au/forums/topic/337467-suzuki-dr-z400s/
Share on other sites

  • 2 weeks later...
  • 2 weeks later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Latest Posts

    • Ok so after much research and talking with knowledgeable people I've got my turbo conversion done and it's all running great other than 1 small issue.  Car has remained auto with the na auto and tcm, I've used a stagea ecu with. NIstune board and everything is great other than my gear selection on the dash. It illuminates park, reverse, neutral, 3rd and 2nd. But nothing drive or what gear your in when you pop it into tiptronic.  I'm sure there is may e 1 wire in the ecu plug I need to move to rectify this. Dose anyone here have any ideas?   Cheers guys
    • Sorry I haven't been following all the detail, so you may have tried this. Does it idle with the tiniest bit of throttle you can add? You've mentioned the IACV, does it have an AAC valve and have you adjusted it at all (ie, screw the idle adjust screw all the way in, then back it out a couple of turns until idle is stable)?
    • My bad, I unplugged the one underlined in red instead of yellow before. With the car started, after unplugging the IACV (the one underlined in yellow), it idled at around 400/500 for 3 seconds before stalling. Attempting to start the car without the IACV will not start the car.   It does stutter and sputter for around 5 seconds before dying. However, immediately after starting it, you can already hear some slight sputters from the exhaust.   It won't start with the AFM unplugged. If it is when the car has already started, it stalls in a few seconds.   Yesterday, I did take some logs using Nistune of 3 scenarios. Car idling till it stalls Car idling and unplugging the IACV Car idling and removing the AFM I also have some previous logs of when the Car is idling till it stalls and when driving and it cuts. I am not really knowledgeable enough to understand what to look for. After every test, car idles rougher and rougher, until I have to stop. It will be fine the day after.
    • There is no difference between a 17x8 and an 18x8. The total diameter of the tyre needs to remain +/- the same (so you don't mess up the gearing, speedo reading, and clearance when turning front wheels..... so you just need to use a lower profile tyre on th 18 than you do on the 17. /rocket surgery.
    • I thought the same to start with. But then I thought it was one of those LCAs where the end of the ARB goes through a bushing in the LCA itself, instead of having an end link.
×
×
  • Create New...