Jump to content
SAU Community

Recommended Posts

I purchased the driver's seat (photo 0374 and 0377) in 1988 for my V6 Capri. Never installed due to the low seat belt mount points and didn't want to install racing harnesses.

I then installed them in a TE Cortina in 1997 and removed when I sold the car in 2002. They both still have the custom mount plates.

Passenger seat purchased from my father, who had installed it in his tipper truck and had written off.

It has a small tear on the rear and one large tear covered with cloth tape. See photo 0381. Also has a shoulder cracked due to sun exposure in the tipper. See photo 0385.

The passenger seat has a DMT approval plate. Please note this indicates how old the seat is. The driver's one does not have one as it is much older. Approximately late 70s.

The driver's seat is in good condition for it's age and the passenger seat will need reupholstering.

Dusty from being in a shed.

Price: $600 for the pair or will consider separating. $400 for the driver's seat and $200 for the passenger.

Pick up either in Chatswood on Mondays only or upper Blue Mountains on any other day,

Also can be viewed in either place. Just either PM or phone to arrange.

Phone: 0425-231-966.

Link to comment
https://www.sau.com.au/forums/topic/365078-for-sale-pair-of-scheel-seats/
Share on other sites

  • 3 years later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Yep, the closest base tune available was for the GTT, I went with that and made all the logical changes I could find to convert it to Naturally Aspirated. It will rev fine in Neutral to redline but it will be cutting nearly 50% fuel the whole way.  If I let it tune the fuel map to start with that much less fuel it wont run right and has a hard time applying corrections.  These 50% cuts are with a fuel map already about half of what the GTT tune had.  I was having a whole lot of bogging when applying any throttle but seem to have fixed that for no load situations with very aggressive transient throttle settings. I made the corrections to my injectors with data I found for them online, FBCJC100 flowing 306cc.  I'll have to look to see if I can find the Cam section. I have the Bosch 4.9 from Haltech. My manifold pressure when watching it live is always in -5.9 psi/inHg
    • Hi My Tokico BM50 Brake master cylinder has a leak from the hole between the two outlets (M10x1) for brake pipes, I have attached a photo. Can anyone tell me what that hole is and what has failed to allow brake fluid to escape from it, I have looked on line and asked questions on UK forums but can not find the answer, if anyone can enlighten me I would be most grateful.
    • It will be a software setting. I don't believe many on here ever used AEM. And they're now a discontinued product,that's really hard to find any easy answers on. If it were Link or Haltech, someone would be able to just send you a ECU file though.
    • Yes sir am asking is there possible way from aem tuner from wiring pins 
    • Have you checked cam to crank timing and confirmed balancer marks are correct?
×
×
  • Create New...