Jump to content
SAU Community

Recommended Posts

Whiteline adjustable castor kit - KCA331 - $100

Whiteline adjustable front camber kit KCA348 - $100

Whiteline adjustable rear camber kit KCA347 - $100 [Whiteline adjustable kits come already in suspension arms & save you the effort of install :)]

HDI Front mount intercooler piping kit (with hoses and clamps) - $80

Right hand side driver's headlight series 2 - $150

Right hand side front quarter (KR4 silver) perfect condition - $80

1 x Right hand side nismo clear indicator - $25

damaged series 2 front bar (KR4 silver) - $50

Full set of floors mats (wear mark on front passenger, rest are perfect) - $100

R33 series 2 driver/passenger seats w/ rails (great condition) - $100 each $180 for both

All interior parts (pm for particular parts pricing)

All parts are located in Wollongong NSW

Thanks :)

Edited by Luke_GTS-T

message me on 0431 121 625 , interested in the whiteline bits and may be interested in front bar pending pics of damage

Picture of front bar.. damage is only on the left side. All pieces are still there just cracked in places.

post-60012-0-82312000-1320394120_thumb.jpg

  • 3 weeks later...

bump parts still here.

immaculate front right guard - $80

door trims perfect - $50 each

LOADS OF STUFF LEFT ! BUY BUY BUY

have you got

- door moulds (the black parts on the outside of the window).

- all 3 windscreen wipers.

- rubber moulds around front and rear windscreen.

  • 2 weeks later...

Hey man give me a message on 0451398017 keen as for a few things if u have them and can come pick them up tonight if u wanna get rid of them cheers anthony

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Latest Posts

    • Tried to make 1/8npt threads into compressor house of the turbo for my EBC. Threads got fu#ked and ended up with and elongated hole, so I do have good amount and nice threads 90% of the hole but 10% I only had 1-2threads there and rest of it is flush on that side of the hole.. So my idea is to do M12 x 1.25 to AN4 with braided lines instead of 1/8npt to 4mm vacuum silicone hose.  and hopefully get a better thread. M12 is quite big and AN4 is a little bit bigger than 4mm (4.9mm inner diameter braided PTFE hose). but this should work. Thoughts? Otherwise I will weld and adapter onto the turbo.   
    • Looks great, I hope everything is working well after all that time!
    • Finally back on the ground and once around the block for the first time in 2+ years
    • Ok a solution was found. I had left the factory oil temp sensor in and it was hooked up. My car never had the triple gauges.  Apparently when you delete the factory pressure and leave the temp sensor connected it triggers the oil light on the dashboard. Disconnected the temp sender, no more light.  I still haven't gotten around to look at the diagrams to figure out how/why they are tied together.
×
×
  • Create New...