Jump to content
SAU Community

Recommended Posts

Hey Guys,

i've owned this car for about 3 years and she's come along way since i brought her in 2009, she's never missed a service either 6000ks or 6 months,i've always taken great pride and care in my cars and maintenance cost isnt important aslong as its quality assured,i've always used Motul xcess 8100 and she has never let me down or given any kind of trouble before, just serviced the car about 2000ks ago with fresh motul 8100 oil, ryco oil filter, cleaned afm, topped up all fluids, new NGK BKR7E spark plugs, shes only done 99,xxxkms i brought her when she was 70,000ks in those 3 years shes never been tracked, the mods listed below some are brought brand new and installed & or tuned by Fussy's Motor Performance, Most of these parts have only done about 2000ks when i gave her a service, im not going to bs and say that i've never gave her a squirt, these kind of cars need it once in a while, anyways i've just brought a house with my missus and atm its just not practical enough for us to start a new family, im not interested in swaps as my gf already has a car and we'll be sharing it untill i get a company car, so im not fussed if she doesnt sell, Shes Never been in any accidents big or small, feel free to do any checks, always maintained with top quality products,So lets start the fun list,

Power:400whp (Approx 295RWkW @ 19.3Psi) with dyno sheet.

Engine:

Stock Standard Internals Genuine 99,xxxkms

Garrett GT3082 .82 Exh Housing Custom Ordered by Tan @ Fussy's

Tial 38mm External Wastegate

Stainless 304 Grade 3mm thick High Mount T3/T4 Turbo Manifold

Screamer Pipe Aiming to the ground

Braided Oil & Water Lines

Bosch Z32 Air Flow Meter

600x300x100 Front Mount Intercooler

Splitfire Coilpacks

Greddy Intake Manifold

Std Throttle Body

Custom Intercooler Piping

Custom Turbo Dump/Front Pipe

3" Cat

3A Racing Pod Filter

800cc Sard Side Feed Injectors + Std Fuel Rail

Bosch 044 External Fuel Pump

1L Surge Tank

Sard Fuel Pressure Regulator

Greddy Type-S Blow Off Valve

Apexi PowerFC + Hand Controller

3.5" Custom Welded Exhaust + XForce Tip

Greddy Profec B Spec-2 Electronic Boost Controller

Golpher 53mm Aluminium Radiator

Interior:

Pivot Shift Light

Speco Volt Meter

Speco Boost Gauge

Apexi PowerFC Hand Controller

Blue LED Dash Lights

Greddy Boost Controller

Nismo Leather Gearknob

7" Touch 2din DVD Player with GPS BT etc..

Exterior:

STD Wheels + Falken Tyres All round 235 45 R17 60%

Full Genuine Altia/Nismo Bodykit

Lowered King Springs

Grey/Black Side Stripes

Vented Carbon Fibre Bonnet (Faded) Can Provide STD Bonnet

Nismo Clear Front Indicators

Nismo Clear Side Indicators

Note:Black TE37's Are Not for sale

$20k

Contact Viet By Email: [email protected] or 0434082008

Dont Call just to give me a lecture bout pricing, im not really bothered about it so dont get angry if i just hang up on you.

post-49795-0-37425900-1353214372_thumb.jpg

post-49795-0-99511700-1353214375_thumb.jpg

post-49795-0-62625800-1353214378_thumb.jpg

post-49795-0-15524300-1353214382_thumb.jpg

post-49795-0-78744300-1353214387_thumb.jpg

post-49795-0-34038700-1353214390_thumb.jpg

post-49795-0-37847800-1353214393_thumb.jpg

post-49795-0-26836200-1353214396_thumb.jpg

  • 1 month later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Latest Posts

    • sold listed as a Tomei LSD 1.5 Way For 1998+ Nissan Skyline ER34 25GT RB25DE w/Open R200 https://www.ebay.com/itm/174006114594?campid=5338967980&mkevt=1&mkcid=1&toolid=10050&customid=&mkrid=711-53200-19255-0&loc_physical_ms=108689&loc_interest_ms=&campid=5338967980&mkevt=1&mkcid=1&toolid=10050&customid=71883f2ccc571356e0a757bc7adfdde2&mkrid=710-53481-19255-0&loc_physical_ms=108689&loc_interest_ms= it went in like butter all gears, alignment, back lash etc, rotation and clearances correct, and if rolling all rotates smooth and free when coasting down road , clutch in or out over 10 mph smooth... its the binding, clunking and jerking from a stop that is most concerning, also seems like its going to tear the tires off in 10 miles of normal road driving. 
    • What 1.5 way? There's no such thing really as a 1.5 way, just different ways of explaining 2 ways with different ramp rates. HOWEVER. In any driving in a straight line your 1.5 or 2 or 1.7 way should have no clunking at all. With the clutch fully depressed the diff should be silent (unless it's welded but I'm assuming it's not). Something aint right here.
    • Clutch is a spec brand, new clutch system,( PP, flywheel, friction disc, etc. pull type) installed 100 miles ago, with no problems.
    • looking for some help and maybe some insight on others experience with a new LSD. R34 GT ran and drove beautifully, but always alot of grip loss due to the open R200 rear end, so I just installed a new 1.5 LSD way into the stock open R200 for a ER34. Simple. Everything seemed right. I test drove for the first time this weekend. as I started to back out the garage the first time slowly with tires straight it sounded and felt like I had a loose or half disconnected drive shaft...that was clucking around loose and shaking entire vehicle, and making it feel like the trans clutch was spontaneously slipping then grabbing very roughly while just letting out pedal slowly. I backed it out went to pull forward with the same noise, shake and slip grab feeling with hesitation, I turned the tires to back out more and then pulled ahead some same thing but worst because of added wheel resistance (which that I expected) puzzled … pulling it back in checking everything over and finding nothing wrong, I tried it the next day. same thing, couldn’t believe how it shook everything again making a terrible noise and making it feel like the trans clutch was slipping and grabbing, but I got it out of garage into the driveway, got it straight, drove forward and then reveres a few times in a straight line everything shaking , causing what felt like clutch slip and grab every time, sounded like right behind front driver tire and I could feel it in the floor board with my feet,... worst right when beginning to let clutch pedal out to engage slightly, shuttering and sounding terrible along the way…I managed to slowly get down the road, babying it the whole way, once I was rolling (out of 1st) seemed to be better and between shifts, then clutch felt closer to normal…not slip/ grab etc., but back down to any stop, straight road or turning, same thing. Made no difference if all tires were straight or if I was turning. All other gauge read out correct. with in 2 miles as planned I reached the empty parking lot and performed the break in procedure that came with lsd, essentially to drive in a figure 8 a bunch.  Did this, binding chattering, and shaking the car the whole way. I drove it back home seemed somewhat normal once I was in straight line and past 10 mph or so, and I know it will “bind” on corners and cause some tires squeal when turning especially from a stop, but when I begin to move it still causes what feels like the trans clutch to slip and jerk badly as well as shaking the entire car, and sounds terrible, that I didn’t expect. I used the fluid they supplied with LSD kit and did the breaking, planning to change fluid as they suggest after breaking, but wondering will it get smoother or less aggressive with use? maybe a 1.5 is just too aggressive for normal road driving?   I have a LSD that I put in my 71 cuda when I restored it, with amazing smooth , quite yet effective results. Different style LSD but that ones a joy to drive. maybe expecting too much from this R200?
    • Join SAU NSW for a flame-grilled feed & flame-spitting cruise! Sunday 17th August 2025 3:30PM Meeting Archies Flame Grille Sylvania Waters 4:45PM Cruise Departure 5:15PM Arrival at Cape Solander Kurnell Meet Location: Archies Flame Grille Final Destination: Cape Solander Kurnell *Disclaimer* There will be a lead and follow car so no one should get lost. If you would like to attend or bring others along please put your name down and a +1 as numbers will be needed prior! This is NOT a race and we will all be adhering to all road rules. If this is what you want please come to one of our many track days. This is an official SAU:NSW event and will be run under a CAMS permit. One of the things that really sets our club apart is our commitment to being true enthusiasts. When on normal roads we strive to maintain good relations with the authorities as well as the public in general. When attending one of Skylines Australia NSW events please try to: • Be aware of surrounding environment and act accordingly. • Drive courteously on the state’s roads as a true enthusiast should. • Understand how important it is to maintain the good name of SAU NSW and thus, treat others accordingly. • Any misbehavior will not be tolerated and you will be asked to leave.
×
×
  • Create New...