Jump to content
SAU Community

Recommended Posts

I have an intercooler kit that was purchased off these forums for sale. It was made by Micks Metalcraft in Villawood, NSW.

CORE dimensions are 600 x 300 x 70mm

Kit includes :

600x300x70 core with polished end tanks

Pipework : (2 1/4 inch - same as std piping size for minimal pressure drop)

pipe that goes into core (start from inner wheel arch),

out pipe from core goes to drivers side wheel arch (a hole must be cut)

the cross over pipe (goes from drivers side wheel arch, up over radiator fan to plug into std pipe that crosses over rocker covers). Mandrel bends.

Silicon Hoses (blue) x 4

Stainless steel hose clamps (x8)

This is a complete kit ready to go in. All u need to do is cut the hole in the drivers wheel arch (easy and not illegal) and make some support brackets for the core to hang off.

Reason for sale : I need a bigger kit for 350rwkw for the RB31DET.

PRICE : $1100 or $1200 delivered to your door!!!

Attached is pics of the core, later i will add pics of the pipework and clamps etc...

:(

edit / WILL SEND ANYWHERE IN AUSTRALIA!!!

Link to comment
https://www.sau.com.au/forums/topic/41623-r32-intercooler-kit-brand-new-1100/
Share on other sites

  • Replies 48
  • Created
  • Last Reply

Top Posters In This Topic

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Well the install is officially done. Filled with fluid and bled it today, but didn't get a chance to take it on a test drive. I'll throw some final pics of the lines and whatnot but you can definitely install a DMAX rack in an R33 with pretty minor mods. I think the only other thing I had to do that isn't documented here is grind a bit of the larger banjo fitting to get it to clear since the banjos are grouped much tighter on the DMAX rack. Also the dust boots from a R33 do not fit either fyi, so if you end up doing this install for whatever reason you'll need to grab those too. One caveat with buying the S15 dust boots however is that the clamps are too small to fit on the R33 inner tie rod since they're much thicker so keep the old clamps around. The boots also twist a bit when adjusting toe but it's not a big deal. No issues or leaks so far, steering feels good and it looks like there's a bit more lock now than I had before. Getting an alignment on Saturday so I'll see how it feels then but seems like it'll be good to go       
    • I don't get in here much anymore but I can help you with this.   The hole is a vent (air relief) for the brake proportioning valve, which is built into the master cylinder.    The bad news is that if brake fluid is leaking from that hole then it's getting past the proportioning valve seals.   The really bad news is that no spare parts are available for the proportioning valve either from Nissan or after market.     It's a bit of a PITA getting the proportioning valve out of the master cylinder body anyway but, fortunately, leaks from that area are rare in my experience. BTW, if those are copper (as such) brake lines you should get rid of them.    Bundy (steel) tube is a far better choice (and legal  in Australia - if that's where you are).
    • EMU Classic. For what I need it to do I see no reason to upgrade. Link and Haltech would both cost an extra chunk of money for a lot of unutilized features
×
×
  • Create New...