Jump to content
SAU Community

Recommended Posts

$14,000

...because this Manual Rexxie Engine has just done 200***Kms

Ph# 0416214699

XT069.jpg

XT054_zpsfd382183.jpg

XT060_zpseff9a0d8.jpg

XT052.jpg

XT062.jpg

* All services done (using full syn oil) and logged + 7 months Rego

* Engine is stock - never been tracked

* Number plates come with the Foz

* No damage or rust. Just a crack on driver's side mirror housing

* Diff back s/s exhaust with nice Rexxie burble and no drone on hwy

* XYZ Coilovers near new with 30 settings

* New front brake pads + spare rear pads

* Whiteline 22mm rear sway bar with HD links

* Ultrex front strut brace

* Nudge bar

* Narva lights

* Side steps (removeable)

* Tow bar - only used to tow SAU.NSW trailer

* Momo gear knob to match steering wheel

* Blue tooth

Link to comment
https://www.sau.com.au/forums/topic/418533-forester-m-y-0-6-x-t/
Share on other sites

MY06XT will be up on a hoist (for camber adjustment) next Wed 13th Feb if one wishes to inspect underneath.

XT047.jpg

...or on top. The stone dent/scratch on the aluminium bonnet has been already repaired and repainted.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Yep, the closest base tune available was for the GTT, I went with that and made all the logical changes I could find to convert it to Naturally Aspirated. It will rev fine in Neutral to redline but it will be cutting nearly 50% fuel the whole way.  If I let it tune the fuel map to start with that much less fuel it wont run right and has a hard time applying corrections.  These 50% cuts are with a fuel map already about half of what the GTT tune had.  I was having a whole lot of bogging when applying any throttle but seem to have fixed that for no load situations with very aggressive transient throttle settings. I made the corrections to my injectors with data I found for them online, FBCJC100 flowing 306cc.  I'll have to look to see if I can find the Cam section. I have the Bosch 4.9 from Haltech. My manifold pressure when watching it live is always in -5.9 psi/inHg
    • Hi My Tokico BM50 Brake master cylinder has a leak from the hole between the two outlets (M10x1) for brake pipes, I have attached a photo. Can anyone tell me what that hole is and what has failed to allow brake fluid to escape from it, I have looked on line and asked questions on UK forums but can not find the answer, if anyone can enlighten me I would be most grateful.
    • It will be a software setting. I don't believe many on here ever used AEM. And they're now a discontinued product,that's really hard to find any easy answers on. If it were Link or Haltech, someone would be able to just send you a ECU file though.
    • Yes sir am asking is there possible way from aem tuner from wiring pins 
    • Have you checked cam to crank timing and confirmed balancer marks are correct?
×
×
  • Create New...