Jump to content
SAU Community

Recommended Posts

Hey all,

I know this topic has been discussed before, but a search didn't bring up any recent topics and didn't really answer my questions.

So, after getting my car stolen from my house last week and being fortunate enough to have recovered it, I'm not going to make the same mistake of being complacent again. I want to make a multi-layered security system for it, ie. hidden kill switches, keypad immobiliser, GPS tracking, the works. The car already has an alarm and aftermarket immobiliser, but that doesn't help too much when they get hold of my keys.

Now then, what is a good solution for a keypad immobiliser? Will be looking to install myself. At the moment I'm leaning towards Sanji - wireless, and comes from the crime capital of the world. Troy, if you read this thread, I'd value your input here.

My other thought was to create one myself. Originally thought it wouldn't be too hard; keypad switch wired to relay, relay to ignition. But this probably wouldn't be as simple to do as I thought, as it would need to rearm itself when the ignition is switched off, plus not sure how it would work with programming a code. So unless someone here has the know-how on how to do that, I'll go with an off-the-shelf item for effectiveness.

Any help would be much appreciated,

Cheers,

Martin.

Link to comment
https://www.sau.com.au/forums/topic/436080-keypad-immobilisers/
Share on other sites

Thanks Gavin, replied.

Can anyone tell me what the 'fail-to-drive circuitry' function does? I imagine it is automatic rearming of the device if the car isn't started for a period of time? And is there any way to obtain the installation instructions, Sanji only give them out to dealers by the looks of it...

I'm a bit of a security fanatic myself. My take on things:

1. Car should be equipped with a properly installed alarm and immobilizer system. As we know, installation is so important. I won't reveal my tricks, but the immobilizer module should cut fuel pump and either starter or ignition. Test yourself: if you can find/access the cut points or immobilizer unit within ~15 minutes of dissassembly, it's not hidden well enough.

2. Once that is covered, if you're parking on the street or in public, always leave your car in gear and with the steering wheel turned 360 degrees from center. If they want to get it on a tow truck, they will need to get inside the car to straighten the wheels or put it into neutral. This will set of your now well hidden alarm, alerting either you, or others. Thieves obviously like to work transparently, so a loud alarm going off while the car is being towed onto the back of the truck will be less than ideal.

3. Well Hidden Kill switch. I like the idea of a keypad immobilizer, but a kill switch will do essentially the same job, and with less hassle/cost. A magnetic reed switch could be used creatively used too. Cut a different point to what you did with the alarm system. Whenever your car is parked at home or for a longer time, flick the switch. If they break in and get your keys, they still won't be going anywhere. If they're stealing your keys, they're driving it away otherwise. Hide it in the boot if you're paranoid!

4. Don't care what anyone else says, old-school devices like steering locks or even wheel locks are a useful deterrent, once all of the above are done.

5. Park out of sight at home. Trust your instinct, if a particular street looks seedy, cough up the $10 and park in a lit garage, and do what I wrote above.

  • Like 1

2. Once that is covered, if you're parking on the street or in public, always leave your car in gear and with the steering wheel turned 360 degrees from center. If they want to get it on a tow truck, they will need to get inside the car to straighten the wheels or put it into neutral. This will set of your now well hidden alarm, alerting either you, or others. Thieves obviously like to work transparently, so a loud alarm going off while the car is being towed onto the back of the truck will be less than ideal.

Had never actually thought of that, it's so simple it's brilliant! I'll be doing that from now on

I'm a bit of a security fanatic myself. My take on things:

1. Car should be equipped with a properly installed alarm and immobilizer system. As we know, installation is so important. I won't reveal my tricks, but the immobilizer module should cut fuel pump and either starter or ignition. Test yourself: if you can find/access the cut points or immobilizer unit within ~15 minutes of dissassembly, it's not hidden well enough.

2. Once that is covered, if you're parking on the street or in public, always leave your car in gear and with the steering wheel turned 360 degrees from center. If they want to get it on a tow truck, they will need to get inside the car to straighten the wheels or put it into neutral. This will set of your now well hidden alarm, alerting either you, or others. Thieves obviously like to work transparently, so a loud alarm going off while the car is being towed onto the back of the truck will be less than ideal.

3. Well Hidden Kill switch. I like the idea of a keypad immobilizer, but a kill switch will do essentially the same job, and with less hassle/cost. A magnetic reed switch could be used creatively used too. Cut a different point to what you did with the alarm system. Whenever your car is parked at home or for a longer time, flick the switch. If they break in and get your keys, they still won't be going anywhere. If they're stealing your keys, they're driving it away otherwise. Hide it in the boot if you're paranoid!

4. Don't care what anyone else says, old-school devices like steering locks or even wheel locks are a useful deterrent, once all of the above are done.

5. Park out of sight at home. Trust your instinct, if a particular street looks seedy, cough up the $10 and park in a lit garage, and do what I wrote above.

Thanks for that mate, agree with all the above points. The car does already have a 5-point immobilizer and alarm system, and I always leave it in gear when parked outside. Steering wheel at full lock is something I generally do, though will always do from now on. My car is always parked in my garage and is never visible outside except for when I am driving in or out. So really my plan now is to make it as hard to steal as possible, even if they do get my keys.

I will definitely be setting up several kill-switches, and my idea with the keypad was more to add another layer to those kill-switches. I just thought about what I would do if I was a thief. If I was trying to steal a car and it wouldn't start, the first thing I would do is check for kill-switches. If there was a keypad there, I think I would be misled into thinking that was the issue. I would probably give up then and there, but say I took the time to pull everything apart and bypass the keypad, the car then still wouldn't start. At which point I could either waste MORE time looking for kill-switches, or move on. Then after all that if they do still manage to steal the car somehow, I will have the GPS tracker as a last resort.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Sounds like you've got an interesting adventure ahead here with local support if you have trouble! My guess is that, unboosted, you will be OK with a small upgrade like -9. What will happen is that once the stock ECU sees more airflow than it expects it will add a heap of fuel and pull a heap of timing to be safe because it can't understand how it could get that much air without there being an issue. You will see clouds of black smoke and it won't pull hard through the midrange and top end. So, overall it will be a bit frustrating but should be OK. If you are still nervous set the base timing back 2o through the CAS, but it will be even more sluggish everywhere. As said above through...this is not my guarantee your engine won't be blown into a million pieces, leaving you looking for very hard to find parts A better idea is get a computer with logging ASAP, wire in a wide band O2 sensor and a use remote tuner. I've done multiple cars this way and while it is not as good as a specific tune on a dyno they can get it 90% right. I'd suggest if you can afford an R33 GTR these days you can afford an ECU and tune. And if you can't afford that you sure won't be able to afford the rebuild if it goes bad in the meantime,.  
    • Yeah it would be nice if someone took the time to put that sort of information together, but there are a lot of variations in looms. I think you are making this way hard for yourself if you just want to get it running....sourcing an SR20 with the right wiring will be a billion times easier than matching the RB loom to an S15 chassis. If you do end up going this way, you just need to trace every wire in the loom with a multimeter, 95% of them will go to a location you can confirm at the ECU.....and then post it up for the next person who needs it  
    • Just top it up with water, and keep a general idea of how much you added. It is normal for water to be pushed into and pulled out of the reservoir through the cap, and it should not be more than half full or it will be likely to overflow when hot. Any decent mechanic can do a pressure test of the cooling system to confirm if you have a leak. Keep in mind if it is only leaking a little and when hot it may well evaporate before you see it hit the ground
    • I'd ask the shop what they used and use that. Mixing coolants is sometimes OK, sometimes not, and you have know the details of each coolant to know whether it's a good idea or not.
    • Is it alright to top up with just another green coolant?
×
×
  • Create New...