Jump to content
SAU Community

Recommended Posts

Is there any way that you can turn the fan off on an R32 climate control unit after you have turned it on without switching the whole unit off using the off button. Also how do you enter the auto mode which controls all the heating and cooling of the car automaticly. I see the auto writing come up once i start the air con but how do u actually get it in to the auto mode and get it working.

Link to comment
https://www.sau.com.au/forums/topic/66216-r32-working-the-climate-control-unit/
Share on other sites

  • 1 month later...

when u turn ur A/C on hold the 'warm' or 'cold' button down 4 like 5sec's

it turns it in FC(****ing Cold) or FH(****ing Hot) hehe

dont ask me wot it really means,personally id rather rip mine out n let my engine air flow thru

  • 3 weeks later...
when u turn ur A/C on hold the 'warm' or 'cold' button down 4 like 5sec's

it turns it in FC(****ing Cold) or FH(****ing Hot) hehe

dont ask me wot it really means

FH is Fast Heat & FC is Fast Cold

But F***ing Cold and F***ing Hot discribe the functions better!

  • 2 weeks later...

Yes it all is a bit confusing. I sat down one day and had a good play just so I could work it all out once and for all. I think I have most of it sussed.

First of all, Air Con cold air actually works better and quicker as a demister than warm air does.

When you first hit the A/C or ECON button this puts it into auto option and the car does whatever it needs to do to get it to the preset temp. If you press the same button a second time it will try and do the same, but without the aircon unit working (basically uses the air from outside to cool down.) You should notice the AUTO display disappear in this mode. Basically, this would be known as the "Fresh" mode on any other car, and is the mode I use the most.

The difference between A/C and ECON? The only difference I can see is that I think the ECON mode has a different temp setting on the thermostat for the aircon unit so it turns off at a higher temperature. This is the case with most other cars with this set-up. It basically takes a little longer to get to the desired temp. It may also kick off when the car has the power put down when in ECON, but I think this actually happens in both modes.

The MANUAL mode gives you the option of controlling the fan speed and vent selection, whilst the car still has the job of getting to the desired temp, again, with or without the aircon unit on.

As far as I know there is no Fresh air option without the fan. I figure they thought that was what electic windows were for.

Now. Go play! :P

i turned my A/C on n had the hot air coming through the front window vents n down on my feet, then turned the A/C off, so now whenever i drive,the hot engine bay air is blown throught the window vents n down on my feet without having the A/C on, if it gets 2 hot i use the electric windows, i find this is most effective 4 my needs:)

mainly coz i stress about fuel consumption n heat around my pod.

when u turn ur A/C on hold the 'warm' or 'cold' button down 4 like 5sec's

it turns it in FC(****ing Cold) or FH(****ing Hot) hehe

dont ask me wot it really means,personally id rather rip mine out n let my engine air flow thru

That is such a cool thing !!!! ( no pun intended ). Went for a belt on the weekend with both windows down and this little trick activated and my feet were nice and warm while the cold air is in my face. :cheers:

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Depending on how long the car sat it is very possible for injectors to be stuck open or closed, I'd get them cleaned and flow tested. Other than that, obviously when the loom changes and the car doesn't start any more....the loom is suspect so some tracing / comparing may be required
    • Harness is for a s1 Rb25det, and it is engine and lower harness.  the old harness had broken off plugs and was in very rough condition/exposed wires and splices etc. it is not able to be put back on the car, I could visually inspect to see if they had rewired any pins on the ecu plug. The fuel pump definitly isn’t turning off it’s an external pump and very loud you can hear it. Will look at the other harness tonight, am also going to pull the fuel rail and watch the injectors spray, will update here with what I find. Pretty sure at this point it has to be something to do with injectors because car will fire up on starting fluid and cas is clicking the Injectors. Fuel pressure is steady 43psi 
    • Check the injectors flow evenly, and are actually flowing what you and the ECU think they should be flowing. If it's starting up on starter fluid, you have a fuel issue. Is it possible under cranking your fuel pump is turning off?   The harness you replaced, is that the whole engine harness? Do yourself a test, and drop the old harness on and plug it into the Z32 ECU. It's possible they've wired things different. From memory S1 to S2 is different in RB25 and you may have a wrong loom
    • I haven’t pulled the injectors to watch them spray yet but they are clicking from the cas and all of the spark plugs are wet with fuel. I’ve thought the cylinders were being flooded from the beginning and was hoping fuel pressure would fix it. Tonight I am going to pull the rail and watch the injectors spray. Don’t know how to test/diagnose if the plugs are firing in correct sequence but that should be a timing thing and as far as timing goes my car still has the half moon for the cas can only install it 1 way. And my mechanical timing is 100% correct I posted photos above. Confirmed with the balancer on and off. 
×
×
  • Create New...