Jump to content
SAU Community

Recommended Posts

i think i saw u vls, i was with my car and a supra, we were standing at the back for a while, i think it was u that drove past, i ran a flat 12.00, next time definate 11's hopefully, yeh that black r33 ran a 11.66 fully worked gtst, big single and all. i dont remember seeing that r31 tho

nice cars guys i was there last nite but not running.. saw the black 33 run 11.9 sounded pretty damn good. also saw 2 gunmetal GTR32's one was doin 12.1's the other a 13.5 but looked dead stock.

Im hanging to get my car on the strip so wen u guys organise another nite let me know i'll b there.

Nope not me  :D

I probably will be out the week after AutoSalon.. you have your issues sorted by the danny?

yeh,, should be all sorted.. im gonna take it out again in 2 weeks.... again with the tune i have.. just wanna get all the lil shitty problems out the way b4 i turn the power up on it...

also use mite have seen my car at the bottom of the straight hahaha the crank angle senor went on it half way down the 1/4 mile i had to roll it in.. still. did a 12.2 tho hahahahhaha

ah the joys of farking around with cars,...

i think i saw u vls, i was with my car and a supra, we were standing at the back for a while, i think it was u that drove past, i ran a flat 12.00, next time definate 11's hopefully, yeh that black r33 ran a 11.66 fully worked gtst, big single and all. i dont remember seeing that r31 tho

yeh maybe i drove passed u... i would have been testin if 2nd was enabling.. god damn B&M shifters.....

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • So for the wide band is a Bosch 4.9 correct for the Link G4+ along with a Can bus? Just get the Link gear or is generic ok too? Eg here: LINK LINK DIGITAL WIDEBAND CAN MODULE WITH BOSCH 4.9 SENSOR : KYP Performance House  
    • Bit difficult to follow. Have a look below and see what the standard R32 layout was like. Note there was a restrictor in place immediately before "turbocharged pressure control solenoid" that, if removed, magically got you 1 bar boost.
    • I might be way off the mark here.. there must be a T junction under the manifold. That takes manifold pressure through a check valve prior to the T, one side splits out to this bleed off orifice, the other straight to the wastegate actuators. 
    • Carrying out some engine due diligence before my first drive in a 260RS that has been in storage for 10+ years, and found two lines that are susposed to be plumbed into the boost control solenoid. One of the lines (the wastegate boost supply line) to actuate the gates, had a bolt in one end blocking it. The other line (main boost signal line) from the very rear of the intake manifold (RB26DETT) and runs up to the boost controller had this pill in the end of it as seen in photos. Other than the obvious (T28 Ceramic turbos might well be cooked)  Can anyone shed any light on if there is any validity at all with this mod, bleeding a constant fixed rate of manifold boost pressure off through this 3mm hole?  Is it deliberate?  Was this a 90s Jap mod done to RB26's? Or has someone just fitted this without any idea of what happens to ceramic T28s if they are not gate controlled?    
×
×
  • Create New...