Jump to content
SAU Community

Kicker kx700.5 Amplifier FS

SKYLINE_GURL
 Share

Recommended Posts

SKYLINE_GURL Enthusiast

SKYLINE_GURL

Posted
Posted

I have a Kicker KX700.5 Amplifier to sell. It was taken out of my skyline in february, I now need the cash. It was purchased and professionally installed in July last year and has been in the box since it was removed from the car.

General Specifications

* Number Of Channels: 5

* Maximum Power: 700 Watts

* Low Frequency response: 20 Hz

* High Frequency Response: 20000 Hz

* Built In Crossovers: Yes

* Channel Separation: Yes

Features

* Power (WATTS/CHANNEL), 2 Ohm Stereo: 85W x 4

* Power (WATTS/CHANNEL), 4 Ohm Bridged Mono: 165W x 2

* Power (WATTS), Class D 2 Ohm Mono: 420W

* Remote Bass Control: Yes

* Fan Cooling: Yes

* Length With Shroud (IN.): 22-1/2"

* Width With Shroud (IN.): 10"

* Height With Shroud (IN.): 2-1/2"

* Frequency Response: 20Hz-20kHz; +0, -1dB

* Input Sensitivity: High Level 340mV-10V, Low Level 170mV-5V

* Signal-to-Noise Ratio: >95dB, a-weighted, re:rated power

* Active Crossover: 12dB/Octave, variable 50Hz-200Hz, selectable high, low, or all pass

* KICKBass Boost: Variable to +18dB, (KX200.4 variable to +18dB) centered @ 40Hz

The AMP comes in the original box with all packaging and certificate. Buyer would need to pick up the amp from either western suburbs or the city as I cant travel around at the moment. Asking $500ono as its an awesome amp and looks as new.

Link to comment
https://www.sau.com.au/forums/topic/78701-kicker-kx7005-amplifier-fs/
Share on other sites
SKYLINE_GURL Enthusiast

SKYLINE_GURL

Posted
  • Author
Posted

blahhh you going to make me measure it...haha I had it mounted in boot against the back wall of an R32 just fine but I will measure tonight after work for you and post it on here

  • 3 weeks later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Latest Posts

    • Julsmadrid
      RB25 Drama's

      By Julsmadrid · Posted

      Thanks GTSboy. I will inspect the valves actually, is this something I can do while they are still in the head? The block/bores don’t look bad to be honest hey, I can still see the cross hatches in the bores and they still measure 86.5mm. I’m not sure how to measure the installed ring gaps but I will do that and take it to someone who can. 
    • oxisau
      Jacks that fit under GTR lips that can reach the subframe?

      By oxisau · Posted

      I’ve had the same headache with my lowered car, scissor jack first then floor jack every time. Ended up grabbing an extra-low profile aluminum jack (about 70mm entry height) and it finally slides under the lip without drama.
    • nash47
      Cas issue

      By nash47 · Posted

      No sync errors , i have installed AEM disk will return original 360 slot disk and check if there’s any one with running AEM disk could share setup 
    • shubby0901
      Living With An R33 Gtst

      By shubby0901 · Posted

      Its been a while! Finally thought to do something on this car, so here we go. This will be a slow burning, multiple posts as I spend 0.5-1hr a day on this job, over multiple days... Full set of GKTech suspension arms!   Step 1: Buy Arms, done! Step 2: Start removing stuff. HICAS was easy. Rear suspension arms are now gone, they were a bitch but breaker bars with long handle extensions, 2 1.5hr slots later, stock arms are off! Next step, remove the hubs and take them to work to press out the bearings and bushings!  
    • GTSBoy
      R34 - Switching cluster from non turbo auto --> turbo manual after diff change

      By GTSBoy · Posted

      I guess. The diff and the speedo are gearbox agnostic.
×
×
  • Create New...