ragzz

I'm in need of the settings of a hanset using a microtech lt10s must be some one that's got a rb30 with a microtech out there .. Iv loaded a mates 33 map an I changed the crank id ref to 6/40 an it's allowed me to start the car so a map for a rb30et would be so helpfull thanks

Hey iv made a bit of a amateur mistake the other day with my handset while it was pluged in , iv downloaded a blank map an never saved my old tune what a headache it's turned into..... Could some one pls help me out with a map to get me car running from their rb30et thanks for any help guys

Then why are u advertising id for ?

Sorry I didn't read earlier post properly did it have 100psi only on 1 an 6 cyl when u did the comp test if so get ready for a build it will more than Likely be the ring lands broken .. That's my two cents anyways

At 100psi compression it would be struggling to idle , have u checked cams position to make sure one isn't out a tooth can be tricky to set up at times ,in turn would give u low comp accross all 6 cyl ..... Because 100psi works out to be around the low 6.0 in comp ratio, witch is very low ....

How's the blow bye is it puffing fair bit out the catch can ?

Sounds like it's got a miss at idle due to the low compression an large injectors how's it run when u bring it up to say 2000 rpm ?

Hi how much for 6x id1300 injectors if U have them

Hello can u let me know if u still have the injectors bud

Hey bud I'm interested in the injectors ATF u able to send some details cheers