-
Posts
10 -
Joined
-
Last visited
-
Feedback
0%
Content Type
Profiles
Forums
Events
Gallery
Media Demo
Store
Everything posted by ragzz
-
I'm in need of the settings of a hanset using a microtech lt10s must be some one that's got a rb30 with a microtech out there .. Iv loaded a mates 33 map an I changed the crank id ref to 6/40 an it's allowed me to start the car so a map for a rb30et would be so helpfull thanks
-
Hey iv made a bit of a amateur mistake the other day with my handset while it was pluged in , iv downloaded a blank map an never saved my old tune what a headache it's turned into..... Could some one pls help me out with a map to get me car running from their rb30et thanks for any help guys
-
Rb30Det Refusing To Run Smoothly!
ragzz replied to Nostalgic R31's topic in Forced Induction Performance
Sorry I didn't read earlier post properly did it have 100psi only on 1 an 6 cyl when u did the comp test if so get ready for a build it will more than Likely be the ring lands broken .. That's my two cents anyways -
Rb30Det Refusing To Run Smoothly!
ragzz replied to Nostalgic R31's topic in Forced Induction Performance
At 100psi compression it would be struggling to idle , have u checked cams position to make sure one isn't out a tooth can be tricky to set up at times ,in turn would give u low comp accross all 6 cyl ..... Because 100psi works out to be around the low 6.0 in comp ratio, witch is very low .... -
Rb30Det Refusing To Run Smoothly!
ragzz replied to Nostalgic R31's topic in Forced Induction Performance
How's the blow bye is it puffing fair bit out the catch can ? -
Rb30Det Refusing To Run Smoothly!
ragzz replied to Nostalgic R31's topic in Forced Induction Performance
Sounds like it's got a miss at idle due to the low compression an large injectors how's it run when u bring it up to say 2000 rpm ?