Jump to content
SAU Community

Brodys_92GTR

Members
  • Posts

    9
  • Joined

  • Last visited

  • Feedback

    0%

Profile Information

  • Gender
    Male

Profile Fields

  • Car(s)
    1992 R32 GTR

Recent Profile Visitors

254 profile views

Brodys_92GTR's Achievements

Rookie

Rookie (2/14)

  • Dedicated Rare
  • First Post
  • Week One Done
  • One Month Later
  • Reacting Well Rare

Recent Badges

0

Reputation

  1. Hey sorry to bump a 14 year old thread. Am I understanding this right? instead of bypassing the amp you wire the specific wires from the amp connector to the 4 rear speaker wires?
  2. Spoke too soon… rear speakers not working even after bypassing amp…. Speakers themselves work, and are hooked up. However only the door speakers play music
  3. Am currently working on bypassing the Rear amp in my R32 GTR as my rear speakers are hooked up but not working. However I cannot get this plug out for the life of me. Nvm I got it
  4. Took switch apart - cleaned with isopropl alchohol and used a little dielectric grease. unfortunately the lowbeam still doesnt work tested the headlight harness and bulb - both work just not when plugged in on the driver side.
  5. Appreciate both of your insights! 72539565196__EFD57503-D70E-4DCE-8237-B388C49136FF.MOV
  6. My first thought was to remove turn signal stalk and see if the plug is wired up backwards. However upon removal I have no clue what wire is the high beam and which is the flasher. Anyone ever have this problem?
  7. Pinch welds, frame rails, sill. IMG_7841.heic IMG_7842.heic IMG_7844.heic
  8. fresh build only making 210hp at 19Psi of boost. Very lazy doesn’t build boost till 5000rpm. So my car just got broken in on the dyno. Fresh build with Manley 86.5mm pistons 9:0:1, Manley h beam rods, BC 264/264 cams. ARP hardware, ACL bearings, HKS GTIII-SS turbos. 3 bar map / Haltech 2500 ECU. After breaking in they threw it on the dyno and tuned it. checked everything. No boost leaks, no exhaust leaks, no shop rags stuck in intercooler piping. It made 210 at 14psi then they increased boost to 19psi and increased injector duty cycle and still the same 210hp. leak down test 10-15%, compression 120 120 140 140 140 140, waste gates are properly adjusted and car hits target boost level. Not sure what it could be. Do not have dyno sheet from shop. They’re going to take it out on the street and data log tomorrow. Anyone have an idea of what could be wrong? Video.mov
×
×
  • Create New...