zephyro90

check this out... fuel rail for side feed rb25

question.... ever since i installed blitz oil relocator kit, i noticed the oil pressure goes down after driving awhile. but during morning start pressure raises as usual. its just after driving for several hour i can see the pressure gauges needle just above first line or 1/4 and sometimes warning oil pressure level warning lights up. what could have cause this?

i know rb25 are high impedance. i might be wrong...

can all the gurus here make a consensus which to use.... street... circuit drag drift rb20... rb25 rb26 rb30 and all the in betweens been reading all 34 pages, confused! and w/ a headache with all the terminologies and technicalities... shed some light to those lay people like us... thank you in advance! great thread btw!

how many piece sare those SARD 550cc injectors, sidefeed? r32 clear headlight covers pic?

any pic? i know hks doesnt have side feed rail. i might be wrong

how much all together then?

pic of the pfc with controller?

will this fit rb25det series 2 motor?

hi... like t grab this items just jap b pillar xtreme clutch matlech braided brakelines (will this suit HCR32 with ecr33 brakes caliper?) can use your HKS cams to fit my rb25det sereis 2? if someone getting the rb head, i would like to get the bottom. can you ship to port moreby papua new guinea, will pay for the freight.

Pm me the pic of the vertex rear bar

do you still have the rear quarter glass (both side)? PM me

if i fit an oil cooler, do i have to remove the water cooler adapter and adapt the sandwich plate to the block or just install it together with water cooler?

same problem with mine.... i used 3M rubber insulation tape and 3m vinyl tape. now i can rev upto 7000rpm no problem thanks to these forum/topic.

what stiffening part or under brces you installed in your r32? im planning of going tracks... please post pic here....

where do you put the AAC valve?

i have a broken stud on no.6 of exhaust manifold. could this be it?

its been a week now... still with the same dilemma

we just finish with engine swap. got my r32 gtst swap with a series 2 rb25det. probls is i can hear a tapping sounds at low and revs. it gett noisier at hi rev. could it be the shims? anyone knows the standard valve clearance? thanks

what i need is the value of the burn diode/resistor "burn diode R420 between R313 and R414"

got an stock rb25det and i having it stalled in my r32. it doesnt start. we havent check if there is ignition and if theres injectors pulse. really need your help on this, since i dont got anyone to turn too and its the first one here in the philippines. thanks burn diode R420 between R313 and R414